PDA

View Full Version : Lamont's New Floor Board Hwy. Pegs Pics


Tango
06-09-2014, 07:30 PM
Finally figured how to post pics . Again.
sddinnh
06-09-2014, 07:33 PM
Those look pretty "spiffy". :thumbup:
Tango
06-09-2014, 07:41 PM
Install was easy. Once I bought a set of composite ramps. :thumbup: Raised the Spyder up just enough. :ohyea: Tom :trike:
bcoulter19
06-09-2014, 07:45 PM
2 questions
1) did you put those on a 2013 ?
2) Where can you go to purchase them?

Thanks,

Bill C.
Tango
06-09-2014, 07:48 PM
2 questions
1) did you put those on a 2013 ?
2) Where can you go to purchase them?

Thanks,

Bill C.

2014
Bought them from Lamont. Look on the main page of sponsors. :thumbup: If the 13's floorboards are the same as the 14's. Your good to go. Tom :trike:
Shana
06-09-2014, 07:51 PM
Did you have to drill any holes to put these on? His is a 14 from his picture.
Tango
06-09-2014, 07:55 PM
Did you have to drill any holes to put these on? His is a 14 from his picture.


Two holes on each floor board. Clamp the bracket on first to position it. Then drill from underneath. I used a small bit, then the larger bit. Also bought a set of ramps to pick the Spyder up. :thumbup:
Lamonster
06-09-2014, 08:05 PM
Glad you got them on. Don't forget to put your caps on. ;)

Here's the install instructions http://lamonstergarage.com/installation-instructions/fbb-install.html
Chupaca
06-09-2014, 08:23 PM
Looks great. The mounting system when floorboards exsist is nice. Nice quality on the hardware..congrats..!! Now go out and stretch..!! :thumbup::ohyea::ohyea:
sjcpanther
06-09-2014, 08:30 PM
I'm wondering how easy these would be to install under a set of Inspector Gadget floorboards on a 2012 RT........ :dontknow:
ARCTIC
06-09-2014, 08:41 PM
The only thing I dislike is that the bracket is held in position by only 1 bolt so it could rotate if you put a lot of weight on it. Are they powder coated or painted? If they're painted I could get a set and weld it where I wanted it and then powder coat them :dontknow:
Lamonster
06-10-2014, 02:56 AM
The only thing I dislike is that the bracket is held in position by only 1 bolt so it could rotate if you put a lot of weight on it. Are they powder coated or painted? If they're painted I could get a set and weld it where I wanted it and then powder coat them :dontknow:
They are powder coated and they don't move when tightened, if they did I would of put a set screw in them.
Lagaffe
06-10-2014, 04:51 AM
Niceeeeee !

I just ordered one set for my olds legs...

:yes:
Bob Denman
06-10-2014, 06:49 AM
http://smileys.smileycentral.com/cat/4/4_17_211.gif :2thumbs: