Exhaust outer diameter...anyone know it?

[AMTJIM]

Does anyone happen to know the outer diameter of the header outlet...or the inner diameter of tubing that slides over it?

[ataDude]

Does anyone happen to know the outer diameter of the header outlet...or the inner diameter of tubing that slides over it?

Had to get it in a round-about way...stay with me here... I just measured the Magic Man adapter pipe (same as stock on the header side). This should get you want.

Where it connects to the header = 2.875" ID.
It also uses the stock gasket = .125" thick per side (2 sides)...
So... 2.875" less (.125" x 2) = 2.625" OD of the header.

FWIW...the Hindle does not use the gasket, so it's header-side ID is also 2.625" +/- a few thou.

And, you didn't ask but the muffler side of the Magic Man pipe is 2.25" OD.

How's that for service?
.

[AMTJIM]

Thanx...Didn't want to remove items just to check until I had some definite down side. Looking at picking up some preformed exhaust sections and fabbing up an undertail or a dual high mount.

[ataDude]

Thanx...Didn't want to remove items just to check until I had some definite down side. Looking at picking up some preformed exhaust sections and fabbing up an undertail or a dual high mount.

Ha.... that's what I'm working on... dual Supertrapps. :thumbup: