View Full Version : 622 trailer question...
flaggerphil
11-04-2013, 11:30 PM
This came to me after I saw a thread about trailer license plates on another part of the forum...
Can the 622 be safely towed by a car or truck? And if it can, do they have conversion wiring harnesses?
Just curious...
:p
Jester
11-05-2013, 06:55 AM
This came to me after I saw a thread about trailer license plates on another part of the forum...
Can the 622 be safely towed by a car or truck? And if it can, do they have conversion wiring harnesses?
Just curious...
:pjust have to order the adapter from Can Am. It pulls just fine behind my 08 XLR. Still do not know why they did not just use a plain 4 wire flat connector. Have phun.
:joke:
NancysToy
11-05-2013, 07:30 AM
It can, and BRP sells an adapter. Easiest to do with a 2011 or later trailer (4-wire). The small trailer disappears quite easily behind a car, however. Remember it is there.
flaggerphil
11-05-2013, 10:06 PM
Cool! I just ordered one...Thanks!
Guesswho
11-05-2013, 11:24 PM
Do these trailers fit all spyder models? I have a 2013 RS SE5. would be cool to get one. I don't think saddle bags will be enough storage for me.
tigerdr
11-06-2013, 06:30 AM
Do these trailers fit all spyder models? I have a 2013 RS SE5. would be cool to get one. I don't think saddle bags will be enough storage for me.
Yes.
rc51ny
11-06-2013, 06:59 AM
just have to order the adapter from Can Am. It pulls just fine behind my 08 XLR. Still do not know why they did not just use a plain 4 wire flat connector. Have phun.
:joke:
You pull it behind you're KLR? I'd love to see that-been looking for something behind my KLR
Trickie Dick
11-06-2013, 07:09 AM
You pull it behind you're KLR? I'd love to see that-been looking for something behind my KLR
I think if you read his post, it says XLR.
Bob Denman
11-06-2013, 12:20 PM
Yes.
Yes... But keep in mind that BRP really didn't intend that the RS bikes be used for towing.
The hitch will bolt right up; but the wiring will be up to you. :shocked:
rc51ny
11-06-2013, 07:04 PM
I think if you read his post, it says XLR.
OPPS! Dyslexia flaring up again. LOL
StillKickin
11-06-2013, 08:13 PM
just have to order the adapter from Can Am. It pulls just fine behind my 08 XLR. Still do not know why they did not just use a plain 4 wire flat connector. Have phun.
:joke:
I have both my 2012 RTS and 622 wired with the 4 wire connector. That way I can use it on any vehicle I own since they're all wired that way. Enjoy!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.