just installed bluetooth dongle; spyder won't start

[AWEInCA]

Hi,

2013 Can Am ST Limited

I just installed the bluetooth dongle. It is the Cam Am OEM and I followed the instructions for installation.

When I turn the key to start it, I get the clicks for the starter but the starter doesn't engage...the message panel blinks and resets (as if I had just turned the key to the on position). There are no error messages.

Any ideas?

Thanks for your help,
Aaron

[jerpinoy]

First of all:welcome: make sure the kill switch is on.

[NancysToy]

Charge your battery. nojoke

[GParch218]

I have had this before. The battery is low. Once charged it worked fine.

[Chupaca]

Did you disconnect the battery for any reason..?? Check the connections make sure they are tight. Then check voltage and charge if needed. Good luck..!! :thumbup:

[AWEInCA]

Thanks everyone! It was the battery. I guess I shouldn't have listened to the radio while I was putting the side panels back on.
I'm usually not timid around machinery but this thing is so complex and cramped. I just knew I had bumped a wire loose or something.

[Flamewinger]

I just got an ST-L and wonder how this works? You can set it up to listen to the radio with BT headset? Can you also add a Satellite radio? Thanks