PDA

View Full Version : Jacking up for the Baja Ron Sway Bar



Spyder ri
04-04-2013, 10:53 AM
Hi all. If I remove the frunk on my RS, will I still have to jack up the spyder to reach all the bolts? I don't have one and didn't want to buy one just for this install. Thanks!



2012 RS SE5
Mods:

Oxford Hot Grips
Bad Boy Air Horn
Two Brothers Exhaust
K&N air filter
LED mud flap lights
Tips Kit
Brake Light Modulator
IPS Key Cover
Up/out mirror Extensions
RSS stitched seat cover
Cal Sci touring windshield
5 spoke wheel upgrade
Ram mount Iphone cradle
LED turn signal indicators
Frunk Liner
BRP 12 Volt Outlet
Third brake light
Double Play tail light

Bob Denman
04-04-2013, 11:02 AM
You'll need to be able to get to the end links on each side... It's easier if you've got room enough to slide up under the bike... :dontknow: You probably should be able to reach everything that you need; it might just be a bit awkward... Good Luck! :thumbup:

Rotaxer
04-04-2013, 11:07 AM
Ramps would probably work too.

Sarge707
04-04-2013, 12:10 PM
No Need on the RS
2 10 mm bolts on bottom
4 10 mm Bolts on top
disconnect
trunk latch
plug thingy
horn wires
sensor wires on other side
Lift trunk right off- Grease fittings while you have it off IF you have grease and gun!!

Bob Denman
04-04-2013, 12:19 PM
No Need on the RS
2 10 mm bolts on bottom
4 10 mm Bolts on top
disconnect
trunk latch
plug thingy
horn wires
sensor wires on other side
Lift trunk right off- Grease fittings while you have it off IF you have grease and gun!! :2thumbs: You might as well grease it while everything's out in the open... :thumbup:

BajaRon
04-04-2013, 04:52 PM
Hi all. If I remove the frunk on my RS, will I still have to jack up the spyder to reach all the bolts? I don't have one and didn't want to buy one just for this install. Thanks!

You will not have to jack the Spyder up if you remove the Frunk. I've done it this way.

Chupaca
04-04-2013, 04:57 PM
No Need on the RS
2 10 mm bolts on bottom
4 10 mm Bolts on top
disconnect
trunk latch
plug thingy
horn wires
sensor wires on other side
Lift trunk right off- Grease fittings while you have it off IF you have grease and gun!!

did mine with out lifting the roadster..:thumbup: You'll have no problem...!!

Spyder ri
04-04-2013, 06:04 PM
Thank you!
Saved me some cashola for another farkle!



2012 RS SE5
Mods:

Oxford Hot Grips
Bad Boy Air Horn
Two Brothers Exhaust
K&N air filter
LED mud flap lights
Tips Kit
Brake Light Modulator
IPS Key Cover
Up/out mirror Extensions
RSS stitched seat cover
Cal Sci touring windshield
5 spoke wheel upgrade
Ram mount Iphone cradle
LED turn signal indicators
Frunk Liner
BRP 12 Volt Outlet
Third brake light
Double Play tail light