View Full Version : Baker Built Belt Tensioner
fencepost
03-18-2013, 10:52 PM
Installed the new Baker Built Belt Tensioner on wife's RT yesterday, very easy install. Remove belt guard (Torx bit #27) for access, remove 15mm nut on lower shock bolt, install kit, put roller on and center on belt, re-check all bolts for tightness. Test drive to verify roller is aligned on belt, re-install belt guard.
64831 64832 64833 64834
Kagey_98
03-19-2013, 05:23 AM
How does it perform?
fencepost
03-19-2013, 07:02 AM
My little test ride to verify roller alignment indicated that it works as advertised. This is my wife’s ride so I cannot speak to any of the performance issues as weather has not permitted us to get out on a performance run.
Bob Ledford
03-19-2013, 11:32 AM
Feed back would sure be helpful.
jerpinoy
03-19-2013, 12:11 PM
Looks good and good pictures
bzbaeren
03-19-2013, 12:25 PM
My little test ride to verify roller alignment indicated that it works as advertised. This is my wife’s ride so I cannot speak to any of the performance issues as weather has not permitted us to get out on a performance run.
I would really like to hear back after you get to try it some more if it reduces harmonics in the drive belt.
flybuddy
03-19-2013, 07:36 PM
Where did you get it? I don't see it on the Baker Built website.
georam
06-01-2013, 09:08 PM
Where did you get it? I don't see it on the Baker Built website. http://www.bakerbuilt.com/bbairwings/page126.html
JkRbbt
06-01-2013, 10:34 PM
Haven't got a lot of miles since I put one on my 2013 RT, but I will say it is a pretty straight forward install UNLESS YOU HAVE A SPYDERPOPS BELT GUARD ALREADY INSTALLED! :gaah: Also, the roller tended to rub just a bit on the factory belt guard. Solved that by taking a file to the lip of the guard. Not a big deal and you can't see the file marks unless you lay on the ground under the bike. Most folks won't be doing that! :D
Chupaca
06-01-2013, 10:48 PM
good pic's and install explanation. We have the smoothryder and it works well. Little more involved in the installation. Will have to see feed back on yours..!! :thumbup:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.