Intake Support Bracket Fell Off

[NorthStar]

The Intake Support bracket (refer to assembly item 46,53,54, - diagram below) has "disengaged" from its mounting position on the engine. I am assuming that this happened while I was shifting the air box to remove and replace the front cylinder spark plug wire.
Unfortunately the shop manual that I have does not illustrate the mounting position of this bracket and the parts diagram illustrated below is rather vague as well. For those of you who have removed the air box on the RT, I would appreciate it if you could point me in the right direction on locating the attach points for this bracket? I am assuming that it is located beneath the air box on the right side of the engine, and if someone can confirm this I will attempt to rummage around and see if I can get it re mounted.

Mike

http://parts.spyder.brp.com/cgi-bin/ImgServ.exe/convert?ilFN=E:\\EmpartWeb\\data\\1s\\06\Y1002\08Y 1002.tif&ilSC=15&ilIV=0&ilBR=0&ilIF=P&ilRE=8

[Lamonster]

http://www.spyderlovers.com/forums/attachment.php?attachmentid=32082&d=1315653527

[NorthStar]

http://www.spyderlovers.com/forums/attachment.php?attachmentid=32082&d=1315653527
Thanks Lamont. That is indeed the detached piece that I am looking at. Now I just have to route around and see exactly where it is supposed to be attached to the engine casing and I should be good to go.

[NorthStar]

I simply won't bother next time.

The fiche diagram had me baffled and you took a stab at identifying it for me. That sort of effort on your part is greatly appreciated. I apologize if I offended you.