Can't find a schematic for part #219800246

[sabunim5]

Hi Folks, Even though BRP replaced my cracked fender brackets under warranty last time they are saying No to another replacement at this time. It is a little frustrating that a body part that you would expect to last the service life of the vehicle is not covered, but so be it. I am trying to decide what to do. One option is to weld and reinforce the cracked brackets. Another option is to fab my own brackets. A third option is to buy new brackets and the new "fender support kit" whose part number is listed above. I can't seem to locate a drawing or schematic of the fender support kit. I would be extremely grateful to anyone that could lead me to that drawing/schematic. It would really help me to make an informed decision on which route to go. Hoping someone out there can help.:pray:

[spacetrucker]

How about a good welder to fix it. That is what I did or you can order it your self . Any good luck. PS, welder was best for me..

[btcherm]

I agree weld it ,would probably last longer.and be stronger.:doorag:

[Lamonster]

One side broke on mine and I welded it, about a year later the other side broke and I welded it and I've not had a problem since. Leave some reinforcement weld on the inside.

[Bob Denman]

Question: Has this part been improved or upgraded for the new year?

[spacetrucker]

No same dum part. Just some where bad and Outhers where good. Mine was put on way to tight and Brock,about two weeks after getting the bie. Hey replaced and in April it did it againe. Then welded it now ok.