Spyder alignement

[va2djd]

How they do the wheel alignement at you're dealer?
I found a good way too do it they performe the alignement on the 3 wheel
that's in front of the BRP factory in Valcourt Performance NC
http://i767.photobucket.com/albums/xx320/va2djd/07a70513.jpg
http://i767.photobucket.com/albums/xx320/va2djd/185aace7.jpg
http://i767.photobucket.com/albums/xx320/va2djd/9c9ed080.jpg

[fastfraser]

Now that is a sweet set-up, laser level and all . Looks like this shop is on the ball.:thumbup:

[JCSMOKE]

Im afraid to do an alignment, I understand that I may have to remove the VTC floorboards, not something I am looking forward to.

[kevorama]

I had Cowtown check mine yesterday before we all rode down to Lake of the Ozarks for our annual 'play' day after SpyderFest. They use a similar setup. It consists of steel bars and a laser level, as well. My alignment was spot on, but apparently there's a calibration that has to be performed on the power assist steering that fixed my issue. My RTS started pulling a little to the left. The calibration has it running perfect now.

[C3517C]

Do you know if that shop made made those tool themselves ? Where are they located ? Dealers I have spoken to seem seem to be fairly clueless about alignment.

[kevorama]

The guys at Cowtown fashioned their own. Double check to make sure that it's your alignment and not something to do with the power assist.

[docdoru]

OK, next Florida x-Press ryde "for the Spyder alignement": BRP factory in Valcourt - Performance NC (maybe they have Turbo Dyno...). ;)