Anyone installed this? "Eastern Beaver Controller"

[kmakona]

"Eastern Beaver Power Controller" This was recommended. I would appreciate hearing from users.​

[jvicker]

Send a pm to Packbuckbrew. I believe he has one installed.

[retread]

I've had the Eastern Beaver PC-8 for 4 years now, 6 switched circuits, 2 unswitched, no complaints.

john

[NancysToy]

I have used the Eastern Beaver 3CS on two Spyders now...after building my own for another Spyder. The Eastern Beaver equipment is tops! Look at their ready-made wiring harnesses, too. I no longer fashion my own wire runs if I can get what I need from Eastern Beaver. Good stuff all the way around, and delivered from Japan faster than you can get stuff from the US sometimes.

[Trickie Dick]

I've had the Eastern Beaver PC-8 for 4 years now, 6 switched circuits, 2 unswitched, no complaints.

john

+1:agree:

[Hawk]

There's a joke in there, but I'm gonna leave that alone.

[Starrider]

Yup, got one on Queen B's Spyder. Here's a pic of the install.
http://www.spyderlovers.com/forums/attachment.php?attachmentid=35778&thumb=1&d=1319540549

[Recluze]

I just installed one and the only thing I have running on it is my gps.

The ready made wire harness was not what I expected. I bought the longest one, 60 inches I believe, and it was not long enough to install the PC-8 in the forward compartment where I wanted it. The only place that it would fit other than that would be under the seat and then it would be too long. I may have misunderstood something in there but I installed it in the forward compartment in front of the radiator reservoir and just added length to make the battery leads reach the battery which was about 10 inches or so. I mounted the relay under the seat forward of the gas fill. It all seems to be fine but I was disappointed that I had to splice into what was a very well made harness.