InspectorGadget
05-17-2010, 08:42 AM
I just installed a powerlet I had in the shop. I have ordered 2 more--1 for the oposite side dash, and 1 for the right side rear pillion rider.
There was just enough room for the powerlet, and I think it would be to tight for the standard 12v cigarette outlet. I did not have to remove the dash, but worked from the side after removing the upper side panel. The powerlet is now tied into my new Blue Sea 6 fuse block.
I have also ordered an angle plug to allow more clearance under the handlebars.
C-YA RL
There was just enough room for the powerlet, and I think it would be to tight for the standard 12v cigarette outlet. I did not have to remove the dash, but worked from the side after removing the upper side panel. The powerlet is now tied into my new Blue Sea 6 fuse block.
I have also ordered an angle plug to allow more clearance under the handlebars.
C-YA RL