Removing Body Panels

[knotayooper]

I did a search and couldn't find the answer:helpsmilie:. Does anyone know how to remove the front fenders and center panel?

Thanks!

[PAPA G]

I did a search and couldn't find the answer:helpsmilie:. Does anyone know how to remove the front fenders and center panel?

Thanks!

I THINK YOU USE A WRINCH:roflblack:

[NancysToy]

Front fender has four bolts underneath...after you remove the front wheel. What center panel are you talking about? The Y-panel in front of the seat, or the trunk lid? Many of the body panel removal instructions are in your Owner's Guide.

[vt228]

best thing is to bye book on spyder from dealer shows how to get everything off spyder cost $125.00

[knotayooper]

Yes I will use a wrench.:2thumbs: Actually I didnt even think of looking in the book:opps:

Any yes, I was talking about the Y panel

Thanks everyone for the responses.

[Roger]

Whats a why panel?:dontknow:

[j45p3r]

Whats a why panel?:dontknow:
The panel directly forward of the seat.

[SpyderWolf]

To remove the console, Y piece, you open the front trunk, frunk. The remove the black plastic piece that covers the fuse block and the BUDS connector by pulling up and out on it. This will expose two screws that you use the torx bit screwdriver piece from your tool kit to remove. Then lift the seat, and you will find 2 black plastic pins. You need to carefully use a flat head screwdriver to pop those pins out of there holders, and then remove the holders as well. The center piece will then lift up and out by pulling it to the rear.

This is for the RS models, I am not sure if the RT is the same set up or not.

[Amanda B]

Oops...everything I needed SO far I got from wonderful people here! Thanks guys!!:D

I've replaced all my panels, it looks like you are already in good hands though!:clap:

[knotayooper]

What service! You guys are the best:2thumbs:

[Oldmanzues]

I trying searching but did not find a answer. Is there anyplace other then a new shop manual that tels how to remove all the panels? All I find in the book is for a few left side panels. This is on the RT.

Thanks for any help.

Old Man Zues

[Eddie]

This is the fast an easy way :2thumbs: :joke:

[Raptor]

This is the fast an easy way :2thumbs: :joke:

:roflblack: :roflblack: :roflblack: LUV IT!!

[boborgera]

This is the fast an easy way :2thumbs: :joke:

What mix do use? 30=1 40=1 or 50=1, Also 87 or 93 octane:ohyea: