PDA

View Full Version : Looking for a solid F3 mech - any recommendations - WV?


chunkmonk
05-12-2022, 07:34 AM
Looking for a solid, dependable, knowledgeable mech to do some upgrades on my F3. Let me know if you know of anyone that you could recommend. Appreciate it.
Navydad
05-12-2022, 08:44 AM
I don't know where you're located in West Virginia, but the guys at the Can Am dealership in Jackson, Ohio are good. They're also very busy this time of the year though.
chunkmonk
05-13-2022, 12:02 PM
Well, Jackson, OH looks to be at least an hour or more North of Charleston. Charleston is 5 hours west of me (I'm close to Harpers Ferry/Eastern panhandle). So that's about a 7 hour ride... A bit far, but I appreciate the input.
CopperSpyder
05-13-2022, 03:49 PM
MotorSportsInc In Hanover PA. Very Good Can Am Dealer, with very knowledgeable service department and prices better than ones a little closer to you. It is a bad time of year to get things done tho because the good ones are very busy this time of year. What upgrades do you want to do?
chunkmonk
05-19-2022, 08:01 AM
Some of my list of farkles, mostly. I don't have a way of lifting the Spyder 24" so installing the anti-sway bar upgrade is out for me. I need to have my FIN installed and my GPS system wired in. I'd like to have the titanium/stainless stems installed on the wheels, and I'd like to balance them before re-mounting (then I can install the FoBo2). I'm not setting the auxiliary or gucci lighting in place until I get the Neutrino Aurora+ (that will be sometime in June). Also, since I have an extended warranty on the bike, I want to find a 'home dealer' that isn't either 3 hours away or doesn't just generally suck.
IGETAROUND
05-19-2022, 11:28 AM
Some of my list of farkles, mostly. I don't have a way of lifting the Spyder 24" so installing the anti-sway bar upgrade is out for me. I need to have my FIN installed and my GPS system wired in. I'd like to have the titanium/stainless stems installed on the wheels, and I'd like to balance them before re-mounting (then I can install the FoBo2). I'm not setting the auxiliary or gucci lighting in place until I get the Neutrino Aurora+ (that will be sometime in June). Also, since I have an extended warranty on the bike, I want to find a 'home dealer' that isn't either 3 hours away or doesn't just generally suck.

If you go to any rallies that Captjam is at, he charges $75.00/hour and is the most competent wrench twister that I know.

Al in Kazoo
CopperSpyder
05-19-2022, 05:04 PM
Some of my list of farkles, mostly. I don't have a way of lifting the Spyder 24" so installing the anti-sway bar upgrade is out for me. I need to have my FIN installed and my GPS system wired in. I'd like to have the titanium/stainless stems installed on the wheels, and I'd like to balance them before re-mounting (then I can install the FoBo2). I'm not setting the auxiliary or gucci lighting in place until I get the Neutrino Aurora+ (that will be sometime in June). Also, since I have an extended warranty on the bike, I want to find a 'home dealer' that isn't either 3 hours away or doesn't just generally suck.

The only dealer with a service department near you that I know of is Ridersville Cycle In BERKELEY SPRINGS, WV 25411; 75 GOOD TIMES DRIVE. the only thing I know about them is one person I know that has an F3 and takes his F3 there for service and he like them.