Suggestions for mounting a camera - 2020 RT

[WilcoJunoHotel]

Anyone have any suggestions for a camera mounting location on the front of my 2020 RT - somewhere that I don't have to drill holes or alter the factory equipment?

I can build a bracket, no problem, but don't see a good place to even put that.

Would prefer to not place it behind the windscreen.

Looking at a Garmin Virb or similar. (The Virb can be controlled by my Nav.)

I already have a helmet cam but the battery runs down after about 2 hours which means I have to keep a usb battery pack in my pocket and run a charging cable to my helmet.

[RayBJ]

I mounted my VIRB in front of and below screen. Ran the wire under the pull-out grille to right side switched power block.
I used industrial 3M 2-sided (gray) to mount and it's holding up well after 4k mi.

[WilcoJunoHotel]

I mounted my VIRB in front of and below screen. Ran the wire under the pull-out grille to right side switched power block.
I used industrial 3M 2-sided (gray) to mount and it's holding up well after 4k mi.

Any pics?

[TIMMB]

I have one in the back also right underneath the top case. Sorry I don't have better pictures.

[RayBJ]

Any pics?

187527

[WilcoJunoHotel]

187527

Using a ram ball mount similar to yours, I am thinking about attaching it to one of the upper fairing deflectors (left or right side) and drilling a hole directly into the upper tupperware for the power.

That deflector looks like it can be replaced easily (and inexpensively) so I might be able to drill some holes then buy a replacement piece should I decide to change it at some point.

[RayBJ]

Pic when done. :popcorn: