View Full Version : Prosport EVO Series Digital Fuel Level Gauge
rwk1129
04-24-2019, 10:08 AM
Anyone successfully installed the Prosport EVO Series digital fuel level gauge on an RT-SE6 (2014)? The gauge has a "selection wheel" on the back where you match the ohm reading of the bike wire that carries the fuel level signal. After installation, the gauge reads 100% regardless of the actual fuel level. Any experience out there?
pegasus1300
04-24-2019, 03:41 PM
I would say probably not any experience. The Spyder has a digital fuel gauge once you disconnect the analog gauges. They will then appear on your screen, but you have to disconnect both.
IdahoMtnSpyder
04-24-2019, 06:47 PM
Anyone successfully installed the Prosport EVO Series digital fuel level gauge on an RT-SE6 (2014)? The gauge has a "selection wheel" on the back where you match the ohm reading of the bike wire that carries the fuel level signal. After installation, the gauge reads 100% regardless of the actual fuel level. Any experience out there?
Looking at the installation instructions for the EVO and the wiring diagram & service manual of the Spyder your only hope is to see if this works. Put the selector switch on #5 and add a 50 ohm resistor into the wire coming from the level sender. The resistance of the Spyder sensor is 290 ohms empty and 80 ohms full. The EVO #5 is 240 & 33.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.