Ryker Protective Steel Grill

[Freezefm]

Good news! The Protective Steel Grill from the Rally fits the front fascia on the Ryker 600! 2 screws hold the front fascia, located under the radiator.

169162

Then the front fascia comes off by prying on the sides.

169163

The grill is held on to these tabs by the 6 flat clips.

169164 169165

It looks real good on the byke! Took all of 10 minutes to accomplish.

169166

Francis

[Peter Aawen]

Just be a little careful, those grille things do reduce airflow volume a whole lot more than you might realise!! Especially if they start collecting leaves &/or other debris that doesn't get thru & builds up quickly!! :shocked:

Yeah, I know they are fitted on other models, but that doesn't always mean they are suitable for ALL models! So I'm suggesting you keep an eye on your coolant level & the temp gauge, it can't hurt or take much effort, but it might save you from an expensive repair! :thumbup:

[Tslepebull]

I think that thing is designed to scoop up roadkill like a spatula. I'm not looking forward to skunk mating season.

[Triumphcycleman]

It's so funny you said that! On my ride last weekend there were no less than 4 dead skunks on the Stonewall Jackson Highway in Virginia. I was thinking, what the heck...?

[Tslepebull]

What can I say, they are twitterpated. 169201

[Nico75]

Hi Peter ref front grill . Temperatures on gauge stay the same , no increase on dash at any speed or long run No problem regards Nico 75