View Full Version : Help needed with installation of lamonster cup holder
Bsmith88
10-29-2018, 06:36 PM
Hi!
I purchased a Lamonster Ram mount for RT with self leveling cup holder. Has anyone else installed one of these? We are having a difficult time loosening the bolts to attach the mounting bracket. The bolts will not loosen. An ideas?
guzzihack
10-29-2018, 07:11 PM
Those allen head handlebar bolts are seriously tight with a little loctite added. I used a hammer drive impact tool left over from my dirt bike days. Worked great on Phillips head case screws on Japanese bikes. A 1/4" impact with the correct size socket might break them loose too. I would be careful though and not round off the inside of the allen heads. Good luck.
Coke
Bsmith88
10-29-2018, 07:13 PM
Those allen head handlebar bolts are seriously tight with a little loctite added. I used a hammer drive impact tool left over from my dirt bike days. Worked great on Phillips head case screws on Japanese bikes. A 1/4" impact with the correct size socket might break them loose too. I would be careful though and not round off the inside of the allen heads. Good luck.
Coke
Thank you!
quasi
10-29-2018, 08:15 PM
those allen heads are 7mm.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.