Trailer harness

[Larry rt]

There was a sponsor that sales wire harness for trailer, RT . Can’t find him now? Can someone tell me which sponsor sold this?

[Cruzr Joe]

Here is the link

http://bigbikeparts.com/link.aspx?ProductGuid=41-162&GetGroup=1&GroupGuid=16

Or call Spyderpops at 501 760-1234


Cruzr Joe

[pegasus1300]

Pierre at Can Am Spyder Accessories makes a good plug and play harness. I use his harness,tho I did modify it to five wire as my trailer is a five wire.

http://www.canamspyderaccessories.com/

[Buckeye Bleau]

I used Pierre at www.canamspyderaccessories.com for mine.

With his plug and play harness and the awesome step by step video, it worked out perfectly for me.

Joe

[Mazo EMS2]

I used Pierre at www.canamspyderaccessories.com (http://www.canamspyderaccessories.com) for mine.

With his plug and play harness and the awesome step by step video, it worked out perfectly for me.

Joe

Ditto..:yes:

[stevencovert]

I used Pierre at www.canamspyderaccessories.com (http://www.canamspyderaccessories.com) for mine.

With his plug and play harness and the awesome step by step video, it worked out perfectly for me.

Joe
:agree:

[billybovine]

The problem with Can Am Spyder accessories trailer harness is the module he is using. It is unpowered and does not isolate the trailer from the Spyder. So depending on the trailer and the lights it has. You may get hyper flash of the signal or hazard lights when the trailer is connected. This has been report on a couple of threads. If you get a short circuit in one of the trailer circuits. The lights on the same circuit on the Spyder will fail with an orange screen and failures messages. For a couple dollars more he could have used the correct isolation converter and these potential problems will be avoided. No hyper flash. Any shorts in the trailer and the the trailer lights will fail. But the Spyder lights will not be affected.

[stevencovert]

The problem with Can Am Spyder accessories trailer harness is the module he is using. It is unpowered and does not isolate the trailer from the Spyder. So depending on the trailer and the lights it has. You may get hyper flash of the signal or hazard lights when the trailer is connected. This has been report on a couple of threads. If you get a short circuit in one of the trailer circuits. The lights on the same circuit on the Spyder will fail with an orange screen and failures messages. For a couple dollars more he could have used the correct isolation converter and these potential problems will be avoided. No hyper flash. Any shorts in the trailer and the the trailer lights will fail. But the Spyder lights will not be affected.

I went back and found I ordered from SHOWCHROME (off EBAY). Came with a relay board, and a heavy wire to run up to battery. I can hear the relays clicking when signals are on. I have read MANY forums where using the existing wiring caused failures of the module (due to grounding I think over time).

[Texas Al]

does anyone make a plug and play for a 2017 F3 s ?

[sylvester]

does anyone make a plug and play for a 2017 F3 s ?

I used electrical connection out of Tennessee for my 17 F-3T Limited