how much clarance is under a 2011 can-am spyder rt

[electricman]

can any one tell me i would like to do my own oil change i was going to make a ramp to work on it //// note my cam-am is not at home it is in the shop thay are servicing the clutch slave cy

[quasi]

can any one tell me i would like to do my own oil change i was going to make a ramp to work on it //// note my cam-am is not at home it is in the shop thay are servicing the clutch slave cy

about 5" I believe.

[electricman]

about 5" I believe.
Thanks for your info "Is this room to get a drain pan ,and to get at the drain plugs any one know

[scott16119]

I lift mine up with a motorcycle jack and put 8" wooden blocks under the tires. This is a nice working height to get a drain pan under and not be to cramped taking out the drain plugs.

[cptjam]

My jack stands at the lowest setting is 12". Gives me room for the drain pan, and room to remove the drain plugs! Depending on your drain pan, I like 6" above it to work.

[Ex Winger]

I use 3 plastic ramps and back the Spyder up on them.Works great and lots of room to work.
Bill

[mpsicon]

Also use 3 plastic ramps, I haven't spilled oil on the ground since!

[Chupaca]

There is enough clearance to do an oil change. I do my oil changes on the ground but you do have to get down low...a full table lift would ge nice ;) but I do have other lifts for other work that can be used if you prefer to raise the spyder for the oil change....:thumbup:

[Highwayman2013]

I use 8" high car ramps under the front wheels. Plenty of room.

[electricman]

I use 3 plastic ramps and back the Spyder up on them.Works great and lots of room to work.
Bill
thanks great for that info:yes: