View Full Version : TriAX handles bar middle mounting screw help
wd8ajj
12-28-2016, 09:29 PM
On the triAx bar is a rubber plug on the top center under the cap is threaded for a mount. Anyone know what the threads are other than metric and bolt size that hole will take. Want to put my GPS there. I saw it on the board at one time but no longer.
THX Gary
IdahoMtnSpyder
12-28-2016, 11:47 PM
On the triAx bar is a rubber plug on the top center under the cap is threaded for a mount. Anyone know what the threads are other than metric and bolt size that hole will take. Want to put my GPS there. I saw it on the board at one time but no longer.
THX Gary
6 mm. I think 1.0 pitch.
IdahoMtnSpyder has it right at 6mm x 1.0. I had just checked the size on mine yesterday to install a Ram Mount ball.
wd8ajj
12-30-2016, 10:23 PM
Thanks for the info. Now to see what length I need. Mouting a Ram Ball so I can put my GPS on it. Offto the hardware store when It stops raining...
In case you didn't know, Ram Mount makes a ball with a 6mm x 1.0 stud.
H2O
finless
12-31-2016, 11:16 AM
In case you didn't know, Ram Mount makes a ball with a 6mm x 1.0 stud.
H2O
Yes they do..... Here is the info.
http://www.rammount.com/part/RAP-B-379U-M616
Bob
SpyderRT
01-01-2017, 07:06 PM
Yes they do..... Here is the info.
http://www.rammount.com/part/RAP-B-379U-M616
Bob
Any pics of this installed around?
wd8ajj
01-01-2017, 09:52 PM
OH well, Have the ball need screw but looks like a 6 or 7Mmm will work. If I cant find one, at least i have the link for the RAM page with one I can order.
Now all registered for Spyderfest and have hotel room. Just have to wait......:yikes:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.