Spyderpops Bumpskid Help/????

[Papahoosh]

Hello,
Installing Bumpskid with LED on my 2016 RT but it doesn't look right to me.
The edge doesn't seem to flushed with the bottom. I only secured the 4 screws for now.
Is this how it suppose to look like?
Thanks for your input.

141707141708141709141710

[AeroPilot]

The Bumpskid needs to stick out to protect the front of the Spyder. Cabinet makers might call this "proud" of the surface, and it will keep you from marring the front cowling it you pull up to a high curbing. There will be some debris get stuck in the gap, but it certainly protects the front and bottom of the Frunk. Main support is to make sure the two bolts along the rear tab get drilled right to attach to the metal flange as described in the directions-- use a dril-stop or other protection to avoid drilling up into something that might be damaged.

[HayRog]

... looks just right to me. I have the same measurements. :thumbup:

[Bob Denman]

Did you remove the OEM skidplate? :dontknow:
If you did: that's the gap that you'll have. :thumbup:

[marty1096]

Nope it's right. I thought mine was wrong also.

Sent from my XT1254 using Tapatalk

[Papahoosh]

It is installed now. Followed all the instructions.

141727

[Mississippi Rambler]

It is installed now. Followed all the instructions.

141727

Looks the same as the one on my F3-S.

And...those guys don't forget who their customers are when needing a little help! Can't say enough good things about their support.

Merry Christmas to you guys!

[Bob Denman]

It is installed now. Followed all the instructions.

141727

:clap:


141736

With all of the extra lighting up front: it'll be tough for anyone to say that they didn't see you coming! :2thumbs:

[ARtraveler]

Looks like problem sol-ved. :bowdown::bowdown: