-
Very Active Member
Originally Posted by dmiles
I used balancing beads in my huge RV tires. Are these commonly used in motorcycle tires?
Not trying to take this thread down a rathole, but when you say motorcycle tyres, are you referring to your 2 wheel motorcycle, dmiles, or your Spyder? I only ask as the Spyder tyres are effectively car tyres, and as such, yes, Dyna beads are used in the Spyder tyres.
Pete.
Harrington, Australia
2021 RT Limited
Setup for Tall & Big.... 200cm/6'7", 140kg/300lbs, 37"inleg.
HeliBars Handlebars
Brake rubber removed to lower pedal for easier long leg/Size 15 EEEEW boot access.
Ikon (Aussie) shocks all round.
Russell Daylong seat 2” taller than stock (in Sunbrella for Aussie heat & water resistance)
Goodyear Duragrip 165/60 fronts (18psi) - provides extra 1/2” ground clearance.
Kenda Kanine rear.
2021 RT Limited , Brake pedal rubber removed for ease of accessing pedal with size 15 boots. Red
-
Ozzie Ozzie Ozzie
-
Very Active Member
Originally Posted by Peter Aawen
Hey Pete (& Daniboy ) - - Well, maybe not really way old, but Daniboy did dig up a thread that hadn't seen any posts since about May last year, not long after that post from dmiles was put - and looking deeper, it looks like dmiles hasn't visited the forum since September last year anyway, so don't be too disappointed if it takes a while to get a response, if you get one from him at all?!
Just Sayin'
Sure the earlier posts are from a year or so ago, Peter, but the post I was responding to was from yesterday, where two people mentioned Dyna beads and “bike” tyres. I was simply trying to confirm if those posters were under the misapprehension that Spyder tyres were the “bike” tyres to which they were referring.
i.e. trying to clarify the old chestnut “Special Motorcycle Use Only”…..meaning don’t try to mount these on a “normal” motorcycle, or on a car, as disaster will ensue…..thus covering BRP’s backside.
Pete
Harrington, Australia
2021 RT Limited
Setup for Tall & Big.... 200cm/6'7", 140kg/300lbs, 37"inleg.
HeliBars Handlebars
Brake rubber removed to lower pedal for easier long leg/Size 15 EEEEW boot access.
Ikon (Aussie) shocks all round.
Russell Daylong seat 2” taller than stock (in Sunbrella for Aussie heat & water resistance)
Goodyear Duragrip 165/60 fronts (18psi) - provides extra 1/2” ground clearance.
Kenda Kanine rear.
2021 RT Limited , Brake pedal rubber removed for ease of accessing pedal with size 15 boots. Red
-
Very Active Member
Originally Posted by Joel The Biker
Here is my homemade balance stand. Just mounted these car tires on a set of scratch-n-dent spyder wheels I got on ebay.
Joel, Looking forward to a side by side before and after of your Spyder with those new wheels and tires! Thanks for all the DIY knowledge!
Safe Rides,
David and Sharon Goebel
Both Retired USAF Veterans
2018 Anniversary Edition RT Limited
Baja Ron ultimate swaybar. Vredestein tires, Baja Ron Front Shock Pre-load adjusters, Pedal Box, See my Spyder Garage
IBA 70020 |
|
-
Very Active Member
+ 1 on Use plenty of Lube & Patience!
I really slop that tyre paste like there is no tomorrow.
Over kill but I do both the rim and the tyre.
I like easy.
And I dont mind to replying to older threads if blokes can pick up some info they were not aware of.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|