spyderpops beltguard ?

[WARWAGON]

Bought one for my 2012 RT never installed. Will it work on a 2015 RT?


Sent from my iPhone using Tapatalk

[Brian Kay]

Bought one for my 2012 RT never installed. Will it work on a 2015 RT?


Sent from my iPhone using Tapatalk

I would think so... That swing arm most likely stayed the same, but do a dry install and see if it fits. I too have purchased one a couple years back and have not installed it. Maybe the spirit will move me.

[bmwlarry]

If you do not have one --- get one! Two weeks ago I was on a trip to Idaho with one other spyder. WE were forced onto (No other choice) a road they were putting down new chip seal. While following the pilot car at less than 15 mph, I have at least 5 stones kick up in my belt. Four resulted on holes in the belt. The other spyder had none. Once home we both ordered belt guards. While installing his we found the PO had already installed one on his. That is why he had no damage and I have a $500 dealer visit coming on the 20th!

[CapeSpyder]

How is the belt guard with the smoothspyder or the baker built stabilizer?

[beefybudds]

How is the belt guard with the smoothspyder or the baker built stabilizer?

I have belt guard with smoothspyder with no problems.
Smoothspyder is a must have in my opinion.

[Frankf]

Got a spyderspops gravel guard but cant figure out how to get to the nut on the belt guard screw to hold it so I can remove the screws and belt guard.

Right now, the screw just spins and does not loosen because the nut turns too. I got the front one off by getting a vice grip on the nut, but the back screw nut is not accessible.

Any one have any hints??

[Lin]

Got a spyderspops gravel guard but cant figure out how to get to the nut on the belt guard screw to hold it so I can remove the screws and belt guard.

Right now, the screw just spins and does not loosen because the nut turns too. I got the front one off by getting a vice grip on the nut, but the back screw nut is not accessible.

Any one have any hints??

The instructions that came with my SPY149- belt guard for 2014 models, mentions using a 10mm deep socket on a ratchet to hold the nuts. "It's easy to feel the nuts and hold the socket in place while removing the screws".

I hope this helps.