-
Active Member
What options to replace driver foot pegs for Floorboards?
What floorboards are you guys replacing your driver foot pegs with? This will be on a 2012 RTs. Will later year OEM floorboards work or does this have to be aftermarket?
Thanks!
Last edited by Peter Aawen; 08-30-2022 at 09:06 AM.
Reason: Removed spaces before punctuation so text to voice can read.... :-/
-
Active Member
I made a set for my 2010. I think the options on the older bikes may be getting a bit sparse. Here is what I did: https://www.spyderlovers.com/forums/...ore-(Many-Pix)
This was about 4 years ago and they are still holding up fine.
2019 BMW C650GT, 2010 Spyder RT-S, 2009 BMW R1200RT,(sold) 2009 Honda Silverwing (Sold), 2009 Kawasaki 500 Vulcan (Sold)
\
-
Very Active Member
My Spyder
-
Active Member
We have a 2011 that had pegs but we wanted floorboards too. There were nice looking 6 1/4" long ones from Lamonster ..... https://www.lamonstergarage.com/comm...-rt-lamonster/ .....but we went with some longer ones from Pierre at canamspyderaccessories.com https://www.canamspyderaccessories.c...-rhino-lining/ We also ordered the "floating" highway pegs at the same time. Love both!
Last edited by Arachnerds; 09-10-2022 at 10:46 PM.
-
Active Member
If anyone sees any Kuryakin Widow pegs..rsvp
-
Active Member
Any of those floor boards work with a manual trans?
Some time ago I found some for my 13 RT but after mounting I found I couldn’t get my toe down to initiate the shift. So I have a peg on the shifter side and a board on the brake side which works out quite well.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|