-
here is another one fog you smart people
-
my answer is in the title
-
-
-
Originally Posted by Zip
"F"
X2
-
D,E,G, and H will never see a drop of water...
A,B, and C will never get water above their outlets...
-
Very Active Member
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
My money is on H when i stand above & pee in it
-
Hmm...
-
i used the word fog, because the 3rd letter is G and that is my answer
-
Originally Posted by cuznjohn
i used the word fog, because the 3rd letter is G and that is my answer
D is blocked off so G will never see any liquid
-
Originally Posted by Zip
D is blocked off so G will never see any liquid
yup your right, i didn't see that
-
A as the outlet is not big enough to continue flow vs the amount in f water entering.
-
without filling it i think "L" will be pretty full before "F" ?
-
It has to be either K or F. I thin "K" will fill before F does to "K" is my vote.
-
Originally Posted by Kwalsh
without filling it i think "L" will be pretty full before "F" ?
L the water goes directly out the bottom before it is filled. it then starts to fill F from it's bottom. since F is lower it will overflow before L can completely fill.
-
Active Member
-
Originally Posted by BitSlayer
It has to be either K or F. I thin "K" will fill before F does to "K" is my vote.
J feeds I which feeds K, the water in J needs to be up to the inlet of I before I will start to fill but before it can do that J will start to empty on the right side thus filling L which feeds directly to F and since F is lower than L, F will fill first.
-
Originally Posted by BitSlayer
It has to be either K or F. I thin "K" will fill before F does to "K" is my vote.
K will never see a drop of water...
Because J will not fill above it's outlet into L; the water will not rise above that same point in the oulet that runs into I.
So K will remain dry.
-
Very Active Member
-
-
Very Active Member
-
I'm thinking G, C's lower outlet should empty before J can fill.
-
-
Very Active Member
Originally Posted by cuznjohn
I counted 20.
AKA Jud Smales, Four Year Spyder Ryder!
"Quando Omni Flunkus, Moritati"
The Critter 2016 RT-S
Cat Bypass from Lamonster
BajaRon Sway Bar
Hella dual horns with relay
BRP Hitch with trailer module
Foam Grips
Adjustable Air Deflectors
Driver & Passenger Gel Pads in Seat
Shorty antenna
Ultraguard half cover
Gremlin bell from my son
Break Stripe Kit from Wrap My Spyder
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|