-
-
Very Active Member
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Very Active Member
the side panel has 1 short screw at the very font bottom behind the front side
panel that pops off.the long side panel slips in behind you lower black air
diverter panel. you will see a brass looking nut
2015 rts-white pearl- mods- '16 F3 fat 6 chrome wheels,
and some little stuff. setback utopia backrest, baja ron
sway bar, oem adj. air deflectors, marlin gps compass,
lamonster fbb foot pegs[modified brackets], lamonts
vibration damper, rock guard, and side case stiffener kit,
. brp comfort seat. , fomozas and
altimax, magic mirror mts, and wide mirrors.
[joyce & irvin toms]
-
Active Member
My wife said it must be mine.
Rawhide Kid
2014 Spyder RT Limited. Cognac
Goodyear, AZ
-
yes the side panel has a short screw, like the top panel in the back, but it is a little longer than the one in the back, by about 1/8"
-
This should be fun....😆
Sorry ...not for you
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
-
Originally Posted by irvin48
the side panel has 1 short screw at the very font bottom behind the front side
panel that pops off.the long side panel slips in behind you lower black air
diverter panel. you will see a brass looking nut Ned.jpg
That's the one! Thanks a million!
(I remember putting a long one in there... )
-
Very Active Member
Try this Bob
Hay Bob,
Try this. it might help:
When a panel comes off, put all the fasteners in a sandwich bag and tape it to the panel. I've never lost a screw when I've used this trick. When I taught auto shop we took a single cylinder motor apart and it had to start upon re-assembly. I used the baggie trick to huge success with classes of 25 to 28 kids in teams.
Lost parts cause::::::::::::: Kaos
Kaos----- Gone but not forgotten.
2014 RTS in Circuit Yellow, farkle-ing addiction down to once every few months. ECU FLASH IS GREAT.
-
-
Originally Posted by Bob Denman
I normally try to do something like that...
But I was in a hurry. This was a "Stealth Project", that the Missus didn't know about...
She was indoors, and I was trying to cut corners.
Bob,
I really did try to pull the side panel without removing the mirror and top panel. I just didn't have enough room to work safely, so I went back to basics.
Glad you got it installed and figured out the missing bolt! So, have you rode it yet?
-
-
Very Active Member
cmonn. real men dont look at directions and videos.
guess im not a real man. i screw up even after looking at
all that stuff.
2015 rts-white pearl- mods- '16 F3 fat 6 chrome wheels,
and some little stuff. setback utopia backrest, baja ron
sway bar, oem adj. air deflectors, marlin gps compass,
lamonster fbb foot pegs[modified brackets], lamonts
vibration damper, rock guard, and side case stiffener kit,
. brp comfort seat. , fomozas and
altimax, magic mirror mts, and wide mirrors.
[joyce & irvin toms]
-
-
Originally Posted by Bob Denman
THAT was the one that I had counted on... The other one: not so much!
Hey, look at it this way, the install is, "Bob approved"!
-
-
bob did you ever install the lights i sent you
-
I didn't use them on my bike...
I gave them to another new Spyder rider, as a "welcome to the Party" gift.
But I DID tell him that they came from you!
(He's a member in here!)
-
-
So which screw was missing? Did you find it?
Bob
-
Originally Posted by irvin48
the side panel has 1 short screw at the very font bottom behind the front side
panel that pops off.the long side panel slips in behind you lower black air
diverter panel. you will see a brass looking nut
Yes! Irvin picked it out for me...
-
Very Active Member
i did find out that on the right side panel, that lower front screw was a long one
from the factory. guess the assembler didnt care . it fit the threads.
2015 rts-white pearl- mods- '16 F3 fat 6 chrome wheels,
and some little stuff. setback utopia backrest, baja ron
sway bar, oem adj. air deflectors, marlin gps compass,
lamonster fbb foot pegs[modified brackets], lamonts
vibration damper, rock guard, and side case stiffener kit,
. brp comfort seat. , fomozas and
altimax, magic mirror mts, and wide mirrors.
[joyce & irvin toms]
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|