-
Active Member
altimax rt 43 215/60/15
altimax rt 43 215/60/15 Just purchase this tire for rear of my 2014 rss .if anyone is running with this tire what air pressure do you recommend to use ?
richie spyder
-
I am thinking of getting that tire for my F3S....
i am interested in feed back as well...
-
Very Active Member
TIRE PRESSURE
I have the same size in a Michelin....and because it has much stiffer side-walls I run mine ( on an RT ) one up at 21lbs cold.....The pressure goes up a bit as it heats up.............Car tires should not be run at higher PSI because they were designed for a much heavier vehicle.................JMHO.....Mike
-
Ah ooooo
-
Very Active Member
I have that tire I use 26 psi no hydroplaning like my 2 kumos I used
-
Very Active Member
Jack
All my life I wanted to be somebody, now I realize I should have been more specific.
2019 Specialized E-Bike COMO 2.0
2018 Jeep Grand Cherokee Overland
2018 Tiffin Phaeton 37BH Motorhome
2015 BMW R1200R LC
2014 RTL SE6 Pearl White
2012 RT-622 trailer viper red
2014 Look 7x12 motorcycle trailer silver and black
2011 Polaris Ranger green
2013 GMC Yukon Denali XL silver oak
2016 Can Am Maverick
-
Active Member
Altimax RT43
Originally Posted by jtoro1
I have that tire I use 26 psi no hydroplaning like my 2 kumos I used
I have been running mine at the recommended pressure of 28 with no issues.
Greetings from Idaho
2014 RT-S,
Barjaron swaybar, chome luggage rack, Ram Mount GPS, 12 volt dash outlet, spyderflap mudflap, Rivco flag mounts, drink2go and custom handlebar drink holders,Driver Backrest,Tri-Axis Handlebars, TRICLed turn signal lights. Custon Dynamic Magic Strobe Brake Modulator, Triple Dash Pouches, "Squared Away" Laser Alignment, Spyderpops Bumpskid, TricLed "Knightrider" LED
2014 RT , White (Mine) Cognac (wifes)
-
Very Active Member
TIRE PRESSURE
Originally Posted by cyclekid58
I have been running mine at the recommended pressure of 28 with no issues.
The ....BRP...recommended tire pressure is for a ...KENDA TIRE ....car tires are different, imho.....Mike
-
Ozzie Ozzie Ozzie
-
Very Active Member
I put this tyre on last year. Runs and rides great at 26psi. Nice bonus having an accurate speedo too.
-
Very Active Member
Originally Posted by Retired 2012
I am thinking of getting that tire for my F3S....
i am interested in feed back as well...
It looks like a great choice for an RT. Not so sure I would want one on my F3. The F3 is pretty traction challenged as it is and going to a narrower 600 treadwear rating tire is GOING to reduce available traction. But then again, you may be fine with that.
I am looking at going with a Yokohama again or a Toyo performance tire for the added traction. I am actually getting better life from the Kenda than I did on the 2013 editions but will not buy them. I do not buy 'made in china' tires. Period. Well as long as I can get something else.
-
Active Member
Altimax RT43
Originally Posted by MZEMS2
I put this tyre on last year. Runs and rides great at 26psi. Nice bonus having an accurate speedo too.
So what I am getting here is I should drop from 28 to 26psi for the altimax? For some reason being stiffer I would need to go the other way to 30psi. Thats why I read these forums, to make some sort of 'educated' decision.
Greetings from Idaho
2014 RT-S,
Barjaron swaybar, chome luggage rack, Ram Mount GPS, 12 volt dash outlet, spyderflap mudflap, Rivco flag mounts, drink2go and custom handlebar drink holders,Driver Backrest,Tri-Axis Handlebars, TRICLed turn signal lights. Custon Dynamic Magic Strobe Brake Modulator, Triple Dash Pouches, "Squared Away" Laser Alignment, Spyderpops Bumpskid, TricLed "Knightrider" LED
2014 RT , White (Mine) Cognac (wifes)
-
Very Active Member
Originally Posted by ssmcclub
altimax rt 43 215/60/15 Just purchase this tire for rear of my 2014 rss .if anyone is running with this tire what air pressure do you recommend to use ?
Their is a "Thread going on the General Altimax RT 43 tire" the Thread is titled" Deanna and mike Thank you", Started by safecracker. Look @ What's New? tab.
Deanna
Current Spyder - 2023 F3 LTD Special Mineral Blue
Red LED NANO Saddlebag Marker Lights with Full Illumination
Sequential Fender LED'S (Amber/Red) with Safety Reflector
Dual Power Plate (12 V & USB ports)
Gremlin Bell
Rear Trunk Organizer (4 holders, 2 Elastic Holders)
Lamonster "Top Cuff" with adjustable drink Holder
SpyderPops Missing Guard Belt
Console Accent Trim (Carbon Fiber Domed Black)
Ultimate F3 Floorboards
Front Fairing Service Access Door Covers (Carbon Fiber Doomed Black)
Sway Bar with Links
Rolo Laser Alignment
Half Cover
A-Arm Daytime Dual Color LED Running Lights with Blinker Module
Hi-Viz DRL and Sequential Mirrors lights
Marinco 12Volt Power Receptacle with polarized leads & slide lock
Show chrome Trunk Shock
Former Spyder - 2014 RTS SE6 Cognac SOLD
-
mounting this tire
Just for grins, I checked out this tire on Amazon to see the reviews there. I found only one. To wit:
"I bought this for the single back tire to a Can Am Spyder RT and it works very well. It was a little difficult to install due to the 1/2" narrower bead, but once on and aired up I am very pleased with it."
So, my question is what's necessary when mounting to overcome this reviewer's "difficulty?"
I have a local tire shop in town which doesn't seem to be particularly bothered when asked to mount a car tire on a "motorcycle" wheel, but it would be nice to prepare them for any difficulty they might encounter.
Thoughts?
Pete
Pete Tamblyn
Cleveland, GA
2020 F3 Limited (black)
Time Out XL1800 cargo trailer
2019 Royal Enfield 650 Interceptor
2018 Kawasaki Versys-X 300
2013 ST (sold)
2015 F3-S SOLD
2014 RT-Limited (cognac) SOLD
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|