Vacuum Hose 2012 RTS SE5

[JimboRTS]

Going to replace the 2 vacuum hoses on my 2012 RTS SE5.
are the hoses 3mm or 4mm?

Jim

[jcthorne]

3mm. Use silicon turbo wastegate tubing and you will never have to replace them again.

[JimboRTS]

Going to replace the 2 vacuum hoses on my 2012 RTS SE5.
are the hoses 3mm or 4mm?

Jim

What is the correct lengths of the two hoses?

Jim

[JimboRTS]

Going to replace the 2 vacuum hoses on my 2012 RTS SE5.
are the hoses 3mm or 4mm?

Jim

Are the factory part number. 420960115 Hose, Sensor the correct part numbers and takes 2 of these hoses?

Jim

[jcthorne]

Just buy 3mm silicone hose and cut to length. Much cheaper, higher quality hose and readily available at your local Napa auto parts. You need less than 10 inches of hose to do both of them. Remove old hose, cut new one to same length and install.

[btcherm]

had to do it to mind just two weeks ago......

[JimboRTS]

Just buy 3mm silicone hose and cut to length. Much cheaper, higher quality hose and readily available at your local Napa auto parts. You need less than 10 inches of hose to do both of them. Remove old hose, cut new one to same length and install.

Went to NAPA, they had to order and hose was 3.175mm, will that work?

Jim

[jcthorne]

Went to NAPA, they had to order and hose was 3.175mm, will that work?

Jim

Yes

[JimboRTS]

Yes

Does any one know the factory part number. Going to use NAPA hose, but what'd to know the factory part number.

Thanks

Jim

[JKMSPYDER]

​I believe the NAPA hose part # is H466.

[JimboRTS]

​I believe the NAPA hose part # is H466.

Thanks for the NAPA part number.

Does anyone know the BRP Spyder part number?

Jim

[nhoj]

Thanks for the NAPA part number.

Does anyone know the BRP Spyder part number?

Jim

420960115 Hose, Sensor

[johnwinslow]

I changed the hoses on my 2011 rt, used the part from Napa worked fine, there is 6 feet of hose in the box, you might want to chk your crank case vent hose mine had cracking on it also. just a reminder the chrome tamper proof screws do not need to be removed they have push pin and grommets to hold the panel on,