-
I got some Troubleshooting Help Today!
Hi I just got a new F3T. I was on a short ride today and looked down and the check engine light Was on, and in the bottom center of the speedo screen an image of the handle bars with an arrow pointing to the right on top and an arrow pointing left on the bottom was flashing. it didn't seem to affect anything...And it ran and steered just fine. 17 miles on it by the way! I really want to ride But don't want to mess any thing up!
Any Help is appreciated!!!
Thanks
Kubie
Last edited by kubie; 07-05-2016 at 06:01 PM.
-
Very Active Member
Looked in my manual and found nothing that could help you. Sorry.
2020 Chalk, RT Limited, Dark and matching RT622 trailer and BRP hitch. BRP Drivers Backrest, Auxiliary Light, Garmin Zumo XT, GPS Support, RT Rear Panel and Travel Cover. Spyderpops LEDs on fenders, mirrors, saddlebags, top case and RT rear panel. Spyderpops Rock Guard. BajaRon Swaybar, Wolo Bad Boy horn, Freedom Windshield, Elka Shocks.
-
The handle bar icon indicates a VSS or DPS faiilue of some kind.
Check battery connection and the pillion switch connector.
Those are the easiest to check & fix.
Check for error codes (MODE-SET-TURNSIGNAL CANCEL)
-
Originally Posted by spyderCodes
The handle bar icon indicates a VSS or DPS faiilue of some kind.
Check battery connection and the pillion switch connector.
Those are the easiest to check & fix.
Check for error codes (MODE-SET-TURNSIGNAL CANCEL)
Ok I Checked the battery and connections were tight. I have no clue what the pillion switch connector is. Could you tell me please... the Warning indicators are still lit!
-
I doubt if it is the pillion switch but it is under the rear service cover (where your tool kit is under rear seat).
The switch is a round thing that clicks when you push it. Follow the wires to a connector. Make sure that connector is tight.
Check for error codes.
-
thanks
Originally Posted by spyderCodes
I doubt if it is the pillion switch but it is under the rear service cover (where your tool kit is under rear seat).
The switch is a round thing that clicks when you push it. Follow the wires to a connector. Make sure that connector is tight.
Check for error codes.
Ok ill check that thanks!
-
No Code
Originally Posted by spyderCodes
The handle bar icon indicates a VSS or DPS faiilue of some kind.
Check battery connection and the pillion switch connector.
Those are the easiest to check & fix.
Check for error codes (MODE-SET-TURNSIGNAL CANCEL)
Also I did the mode- Set- Turn signal Cancel to find the code and its just a blank screen. i did this several times and no code!
-
Originally Posted by kubie
Also I did the mode- Set- Turn signal Cancel to find the code and its just a blank screen. i did this several times and no code!
My troubleshooting advice then is better see your dealer since it's brand new, no codes and connectors are tight.
The DPS usually returns an error code.
-
Pillion Switch
Originally Posted by spyderCodes
My troubleshooting advice then is better see your dealer since it's brand new, no codes and connectors are tight.
The DPS usually returns an error code.
Well i looked and found the switch but tracking the wires is a no go they are hidden under all the Tupperware. oh well thanks for all the help! I really appreciate it ! So no ride till Tuesday to take it back! Oh Well Thanks again!
-
I have had the VSS kick in on a long slooping curve. Like a racetrack banked curve and way towards the end. Now hit those curve and do some wiggling so the VSS dosen't think I'm going over... It is something for them to check. I would think your connections are good and the DPS is fine or you would know something is up. Keep us in the loop....
Sent from my SM-T560NU using Tapatalk
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
ok
Originally Posted by Chupaca
I have had the VSS kick in on a long slooping curve. Like a racetrack banked curve and way towards the end. Now hit those curve and do some wiggling so the VSS dosen't think I'm going over... It is something for them to check. I would think your connections are good and the DPS is fine or you would know something is up. Keep us in the loop....
Sent from my SM-T560NU using Tapatalk
Ok i will I feel like the little kid that opened a present at christmas time and it was broken outta the box!!!! I just want to go play with it! But i cant!!! LOL
-
let me ask you...have you shut her down and removed the key walked away say for 30 minutes or so..? if not try that and see if the messages clear. if they do take another ryde and if they don't come back it could be a glitch...one can hope...
Sent from my SM-T560NU using Tapatalk
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
Yes
Originally Posted by Chupaca
let me ask you...have you shut her down and removed the key walked away say for 30 minutes or so..? if not try that and see if the messages clear. if they do take another ryde and if they don't come back it could be a glitch...one can hope...
Sent from my SM-T560NU using Tapatalk
Yes I have several times. i keep reading what you guys post then go do that.... and then come back in and read somthing new and go and check that every time i fire it up the check engine light comes on and the orange handlebars light comes on too!
-
Very Active Member
That's horrible hope you get it sorted out. Sorry you missing riding time hope they compensate you for the trouble...
Live, Love, and Ride! God Bless!
-
Sunday like you need to have the steering sensor calibrated... Take it in to the dealer, if that is the problem you should be in and out in 30 min..
mark
-
I just wanna ride!
Do you think it will hurt to ride????
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|