2015 RTL Headlights Won't Switch Between Hi-Beam & Low Beam

[Synthetic]

Any ideas why I can't change from Hi-Beams to Low-Beams on my headlights?
It used to make quite a racket when switching but now makes no noise and lights do not change...
Thanks for any help....

[spyderCodes]

You might start by checking fuse 5 in the right hand jcase box. The lower, larger fuses.
It could be loose.

[BLUEKNIGHT911]

F-3 now has twin filament, but if yours has the SHUTTER I have a doubt both became STUCK at the same time !!!! so it could be the switch has failed ......it's under warranty .....and Pitbull is just down the road .......Mike

[Synthetic]

I checked fuses 5, 6 and 7 on right side fuse box and all were fine.

I'd say it has the shutter set up as it sounds like a shutter when operated....at least it used to.

[SpyderAnn01]

Are you stuck on high beams? Then the shutter is stuck open. Usually one side will go wonky and the other side will still operate normally.

[Synthetic]

Are you stuck on high beams? Then the shutter is stuck open.

SpyderAnn, I can't tell if it is high beam or low beam....the high beam low beam indicators work but nothing else changes...

[Synthetic]

I did just replace the headlights and fog lights with TricLed LED's.....but I'd think just changing out the bulbs for LED's would not cause this to happen...

[spyderCodes]

I checked fuses 5, 6 and 7 on right side fuse box and all were fine.

I'd say it has the shutter set up as it sounds like a shutter when operated....at least it used to.

There isn't a 6 or 7
Take a look on page 153 of your owner's manual

[Synthetic]

There isn't a 6 or 7
Take a look on page 153 of your owner's manual

You're right it is fuses 3, 4 & 5 ....I shouldn't go by memory....