-
Active Member
Custom LED Magic Strobes Brake Light
Just wanted to verify what I think it correct. Looks like the 2015 F3S, has three wires for the brake light. I wanted to install the Custom LED brake light strobe that I have on my 2012 RTL, when I bought the one for my RTL, they had a CanAm kit. Looks like they only have the universal one. Below is the requirement listed, can someone confirm that it will work.
Your vehicle must have a dedicated brake light circuit in order to install this product. The means, a circuit that has +12V on it only when the brakes are applied.
Let the Farkling commence on the new bike.
Thanks in advance
-
Registered Users
There are 3 wires going to each dual filament bulb. One is ground, one is running light and the other is brake light. Use a 12v tester and you will be fine.
-
Very Active Member
The F3 combines the brake and turn signal circuits. You can use the magic strobe but you will need two of them. One for each side as they cannot be tied together. I have them installed on my F3.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|