Centering clamp webbing on Front tires

[pitzerwm]

I don't know about you but my fat fingers have a lot of problems getting the ratcheting webbing centered on the front wheels when tying it down on the trailer. This was my solution. The plastic was from a protein container about 6" in diameter. I was in a hurry so hadn't sanded off the edges in the pixs. You could use almost anything to attach, I had some copper rivets, so I used them.

[jerpinoy]

Nice idea, you can use a deburring tool to make it look nicer.

[Chupaca]

saves all those trips to check front to back...

[BLUEKNIGHT911]

I don't know about you but my fat fingers have a lot of problems getting the ratcheting webbing centered on the front wheels when tying it down on the trailer. This was my solution. The plastic was from a protein container about 6" in diameter. I was in a hurry so hadn't sanded off the edges in the pixs. You could use almost anything to attach, I had some copper rivets, so I used them.

Bill nice idea..........I think you and I are the only Spyderlovers doing " THE TIRE TIE DOWN THING " as opposed to the Rims and or suspensions etc......PS, if you lower your TIRE pressure to about 10 lbs the strap is not going to move when you Rachet it tight......Mike , see you at Spyderfest

[pitzerwm]

Now that they can do it easier, more will try it.

[BLUEKNIGHT911]

Now that they can do it easier, more will try it.

.........No they won't , it's too simple, too easy, too fast, annnnnnnnnnnnnnnd way to in-expensive ( I only do the rear tire )........Mike

[Grandpot]

Trailer?

[Frank G]

I purchased these tie-downs at E-Trailer.com, they work great.