-
-
lift
Nice looking lift - wish you were my neighbor!!
-
-
Very Active Member
with a full floor like that, what are you going to do when you get it raised up??
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Originally Posted by Cruzr Joe
with a full floor like that, what are you going to do when you get it raised up??
Cruzr Joe
Joe, it makes a heck of a work table.
-
Very Active Member
Originally Posted by Cruzr Joe
with a full floor like that, what are you going to do when you get it raised up??
Cruzr Joe
I was thinking the same thing
-
Very Active Member
Originally Posted by bmccaffrey
I was thinking the same thing
Me too. How do you reach in to the engine area?
Great to work on the front wheels/brakes though.
2008 GS SM5, Full Moon Silver
2007 Piaggio MP3 - 250cc
-
Very Active Member
it was fun while it lasted.
-
Originally Posted by coz
was that you or the factory?
All me. I was a welder Field Engineer for major manufacturers for 25 years. I now have a mig welder and a plasma cutter. Most things are possible. I had to use wood ramp additions as the nose would have hit with the stock configuration. The reach in is not too bad. I am now pulling plastic now getting ready to install heat gear lead, GPS, and remote door activator. The door opener is easy, just add two wires to the remote then install a momentary pb switch. See ya.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|