-
Rockin Member
Help Removing Gloryder insert.
So I am scheduled for a Laser Alignment and I'm trying to remove the insert before my appointment. Is there some method of removing the insert without having to take the wheel off?
uploadfromtaptalk1400080795505.jpg
Sent from my SAMSUNG-SGH-I467 using Tapatalk
2011 Pearl White RT Limited
HMT Brake Light, Fender Tips Kit, Mudflap Lights, GloRyders, Seal Floorboards, Powerlet 12V, Garage Door Momentary Button, Bump Skid, Elka's Stage 1, Ultimate Sea, Air Wings
Member of the Woodstock Spyder Ryders (Illinois)
-
Very Active Member
Slide Hammer with a wide hook (first accessory in picture, left to right).Slide hammer.jpg
HFT has it on sale... going to buy one! http://www.harborfreight.com/15-piec...-set-5469.html
Last edited by bullant12; 05-14-2014 at 10:39 AM.
May all your encounters with the law begin with the words: "nice trike!".[/B]
2015 Can-Am Spyder F3-S SM-6 Can-am Red/Black SM-6 with 2010 Black RT-622 trailer (hitch in the works).
Previously owned:
2010 Can-Am Spyder RT SM-5
2011 Can-Am Spyder RS-S SM-5
2013 Can-Am Spyder RT-S SM-5
-
Rockin Member
Thanks I'll look into this.
Sent from my SAMSUNG-SGH-I467 using Tapatalk
2011 Pearl White RT Limited
HMT Brake Light, Fender Tips Kit, Mudflap Lights, GloRyders, Seal Floorboards, Powerlet 12V, Garage Door Momentary Button, Bump Skid, Elka's Stage 1, Ultimate Sea, Air Wings
Member of the Woodstock Spyder Ryders (Illinois)
-
RT-S PE#0031
Originally Posted by bullant12
Make sure you loosen the three set screws first! They may just slide out once those set screws are lose.
Mark & Mary Lou Lawson
Snellville, GA USA
'10 RT-S PE #0031
'10 RT-622 Trailer
'08 Yellow SM5 #2332
'01 Black GL1800A Goldwing #0930
"Remember in the darkness what you have learned in the light." - Joe Bayly
-
Rockin Member
I removed all set screws. Thanks
Sent from my SAMSUNG-SGH-I467 using Tapatalk
2011 Pearl White RT Limited
HMT Brake Light, Fender Tips Kit, Mudflap Lights, GloRyders, Seal Floorboards, Powerlet 12V, Garage Door Momentary Button, Bump Skid, Elka's Stage 1, Ultimate Sea, Air Wings
Member of the Woodstock Spyder Ryders (Illinois)
-
Very Active Member
What Mark said. Mine just slide right out.
USAF '69-'89 E7
Thailand/Vietnam 1972
Member: Royal Order of Rat Bastards
-
Very Active Member
Originally Posted by MarkLawson
Make sure you loosen the three set screws first! They may just slide out once those set screws are lose.
Originally Posted by bruiser
What Mark said. Mine just slide right out.
Sometimes they do... but we've encountered a few "stubborn" ones that are just pressured in. That is where the slide hammer comes in. The nice thing about the slide hammer is that it will leave no scratches on the rim... however, watch your fingers when sliding the weight bar!
May all your encounters with the law begin with the words: "nice trike!".[/B]
2015 Can-Am Spyder F3-S SM-6 Can-am Red/Black SM-6 with 2010 Black RT-622 trailer (hitch in the works).
Previously owned:
2010 Can-Am Spyder RT SM-5
2011 Can-Am Spyder RS-S SM-5
2013 Can-Am Spyder RT-S SM-5
-
Rockin Member
I remember installing them was a very tight fit.
Sent from my SAMSUNG-SGH-I467 using Tapatalk
2011 Pearl White RT Limited
HMT Brake Light, Fender Tips Kit, Mudflap Lights, GloRyders, Seal Floorboards, Powerlet 12V, Garage Door Momentary Button, Bump Skid, Elka's Stage 1, Ultimate Sea, Air Wings
Member of the Woodstock Spyder Ryders (Illinois)
-
Very Active Member
Originally Posted by Macca
I remember installing them was a very tight fit.
Sent from my SAMSUNG-SGH-I467 using Tapatalk
When you re-install them use a little emery cloth on them first.
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Registered Users
Originally Posted by Macca
I remember installing them was a very tight fit.
Sent from my SAMSUNG-SGH-I467 using Tapatalk
If you have powder coating that seems to bleed over into the ID of the hub. We typically have to deburr those to get the mandrels in the hub. If so the gloryders may fit a little looser once they are done.
Clifford Fargason
2013 Spyder RTL
2007 Royal Star Venture
-
Rockin Member
Worked like a charm! Went to HFT bought the slide hammer and used the wide hook. Thanks so much for the help.
Sent from my SAMSUNG-SGH-I467 using Tapatalk
2011 Pearl White RT Limited
HMT Brake Light, Fender Tips Kit, Mudflap Lights, GloRyders, Seal Floorboards, Powerlet 12V, Garage Door Momentary Button, Bump Skid, Elka's Stage 1, Ultimate Sea, Air Wings
Member of the Woodstock Spyder Ryders (Illinois)
-
Active Member
Ream the wheel hub a little............
When Lamont checked my RT-S for alignment, I had removed the GloRyders but told him one of them was so tight that I had to remove the wheel and tap out from the back. He took his trusty Dremel tool and reamed the hub hole a little larger until my GloRyder slipped in and out very easily. Thanks Lamont!
Jim
-
Rockin Member
So I thought it would be a piece of cake since the right side came off with a little effort from the slide hammer. Not so with the left side. It is so stuck I am going to have to wait and have the service tech take the wheel off as I dont have a jack.
After calming down I thought to give it one last try with the Slide Hammer and this time it moved!
I was finally able to get the insert off. I don't think I will replace these inserts unless I can get them to easily slide back in.
Thanks for all the suggestions and support.
Sent from my SAMSUNG-SGH-I467 using Tapatalk
Last edited by Macca; 05-14-2014 at 03:05 PM.
2011 Pearl White RT Limited
HMT Brake Light, Fender Tips Kit, Mudflap Lights, GloRyders, Seal Floorboards, Powerlet 12V, Garage Door Momentary Button, Bump Skid, Elka's Stage 1, Ultimate Sea, Air Wings
Member of the Woodstock Spyder Ryders (Illinois)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|