2013 Spyder RS - ST Handlebar Swap

[mudcruiserman]

Ordered my ST bars and will do the swap this weekend!

packbuckbrew-others-Do you have a parts list for this conversion?
Is it all the ST handle bar parts in the diagram "ST" box from BRP?
Does any seller sell it as a package?
Best place to buy? Forum supporting venders?
Thanks

[hchays]

packbuckbrew-others-Do you have a parts list for this conversion?
Is it all the ST handle bar parts in the diagram "ST" box from BRP?
Does any seller sell it as a package?
Best place to buy? Forum supporting venders?
Thanks

You'll need to order the following parts from a BRP dealer.


(1) #115 comes in black or silver
(1) #94
(1) #95 SM5, #92 SE5
(2)#4
(4)#5 if you want to put new mounting bolts.

[slider1898]

Thanks for the handlebar swap info , I ordered mine today from my dealer and the part manager was surprised that the ST would fit, I've also ordered floor boards fro ISCI, I'll let you know how I make out.

Thanks again

[hchays]

Cool, good luck!!

[slider1898]

Just finished replacing 2013 OME RS handlebar's w/ ST bars, everything fit good, a couple tips if swapping bars, watch for a 3/16 x 3/4 " +- spring when taking the ignition apart ,--- be careful when taking the trunk & seat cables off from under the bars , maybe ( lubricate a bit before removing especially if you end -up removing them a few times ) --- the left plastic cover that goes under the new ST bars has a split on one side (it is supposed to be there according to my dealer (its not broken)

FYI -- Also finished installing new floor boards , not exactly a great experience , cost more the web site stated, got different design than ordered, two small important screws missing & to top it off they supplied the wrong instructions.

[Fig]

Thank You!!. Is BRP the only ones that sell the ST Bars? What is the difference between the Stock and the ST Bars. Do bring them closer to you, like the risers?

[hchays]

Thank You!!. Is BRP the only ones that sell the ST Bars? What is the difference between the Stock and the ST Bars. Do bring them closer to you, like the risers?

The ST bars are stock handlebars from a Spyder ST. So Your Can-Am dealer will be the only place you'll be able to get them. In an above post you
l see a parts list that you will need to order for the install. I think all the parts total out to right around $200. The ST bars will bring the handlebar position up and back to give you a more upright and comfortable riding position. The really cool thing is, since they are stock Can-Am parts your Spyder still keeps the stock look.

[Principalgrandpa]

Hi,
I'm doing the swap. Where does the little spring go? My spring fell out when I took the ignition switch apart.

Thank you for any help that you can give.

Al Schroeder