|
-
 warning sticker advice needed
For those that have put the "Warning, Do Not Mess With My Spyder" sticker on their safety card, what did you find the easiest to remove the old safety sticker? It would look goofy going over the top of it, but mine looks to be glued on there pretty good...
Thanks.
-
-
Very Active Member
I think Lamont designed it so the Warning part of the old sticker still shows on purpose. That way it reads, Warning, Don't Mess with my Spyder.
-
-
spyder warning.jpg unfortunately I got the rectangle one... didn't see the bigger "form fit" version. Might have to try the heat... or I might see if I can order a replacement plastic piece if it comes without the factory warning...
-
Very Active Member
Or
 White 2013 Spyder RT Limited. BajaRon Swaybar, Custom Dynamic Third Brake Light. Ultimate Custom Black and White seat with driver and passenger back rest. Gloryder Led Wheel lights.Custom Dynamics Led Bright sides, Amber and Red Fender lights, and Saddle Bag Bright sides.
2016 F3 Limited Intense Red Pearl. Lidlox, BRP Driver Back Rest, BRP Passenger Back Rest,Fog Lights, GPS, Signature Light! Custom Dynamics LED Bright Sides, Amber and Red Fender lights, and Saddle Bag Bright Sides.
-
-
Very Active Member
Ouch
That spider bite is going to hurt.
White 2013 Spyder RT Limited. BajaRon Swaybar, Custom Dynamic Third Brake Light. Ultimate Custom Black and White seat with driver and passenger back rest. Gloryder Led Wheel lights.Custom Dynamics Led Bright sides, Amber and Red Fender lights, and Saddle Bag Bright sides.
2016 F3 Limited Intense Red Pearl. Lidlox, BRP Driver Back Rest, BRP Passenger Back Rest,Fog Lights, GPS, Signature Light! Custom Dynamics LED Bright Sides, Amber and Red Fender lights, and Saddle Bag Bright Sides.
-
Agree..!!
hair dryer then goop or other glue remover to clean it up. 
2012 RS sm5 , 998cc V-Twin 106hp DIY brake and park brake Classic Black
-
Very Active Member
I removed that whole panel, I thought it was stupid....and it got in the way of radar detector wires. LOL
.
-
Is it just me or does the warning card look like the part that bends is going to tear apart if you use it too often? It's just a bend in the plastic, and you can see the wear and tear on it. I have a similar sticker, but in fact the more you use it the floppier it gets. I put some gorrilla tape on it in the hope that it'll give it a little more longevity if possible.
-
Very Active Member
I have a spare if yours breaks. 
-
Has anyone ever had one break?
-
I put "Miss July" on mine... 
-
Very Active Member
-
Very Active Member
buuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuuu uuuuuuuuuuuuuuuuut !!!!!
-
Very Active Member
-
-
Very Active Member
-
-
-
Very Active Member
[QUOTE=SNOOPY;748227]I removed that whole panel, I thought it was stupid....and it got in the way of radar detector wires. LOL
Notice to the Dog, you have voided your warranty by removing that essential part.
Anonymous
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
-
-
Very Active Member
Locked and loaded baby, bring it 
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
Reply With Quote
... try a hair dryer! 
Geez... Put that picture away!!! 
Originally Posted by Bob Denman
BRP's Warranty Enforement Division is one it's way to your doghouse; impoundment, confiscation, and banishment procedures will be implemented! 