Trip Meter

[Doug]

2013 ST Limited Trip meter, after a fuel fill up, I push erace and push resume for both A and B sometimes it works, then other times it don't,am I MISSING A STEP

[ARtraveler]

You may have accidentally paused it. When it says RESUME it is on pause. When it says PAUSE, it is on.

[quickster47]

Pushing the UP arrow pauses the trip and the DOWN arrow resets the trip.

Carl

[NancysToy]

You should have to pause or resume it. If it is accumulating normally, you can simply erase (reset) either one (or both). If it says "Resume" you have inadvertantly paused it. It needs to say "Pause" to be registering.

[Pennyrick]

Can you imagine having light switches that show the word ON when they are off and OFF when they are on?

I can't either and you can't blame it on the French to English translation.

[NancysToy]

Can you imagine having light switches that show the word ON when they are off and OFF when they are on?

I can't either and you can't blame it on the French to English translation.

It is a bit different here. With verbal instructions you would tell someone either to RESUME (start back up) or PAUSE (stop). With written digital instructions it is much the same, hence the display we have. One answer would be to show both commands, and highlight the active one. As an alternative the active state could be shown alone, but it should say something else, like "Paused" and "Active", unfortunately then the means of changing it would not be obvious.

[Doug]

its like saying NO but your really saying YES you know what I mean or maybe you don't

[Jedye]

its like saying NO but your really saying YES you know what I mean or maybe you don't

I chuckled. Picturing the Spyder saying "My 6inch backlit LCD screen is saying 'No' but my IEEE Syntac-Resistored Processor is saying 'Yes'."