Results 1 to 6 of 6

Thread: Rear Trunk Lid

  1. 07-08-2013, 02:43 PM #1
    BlueRTS
    BlueRTS is offline
    Registered Users
    Join Date
    May 2013
    Location
    Columbia, SC
    Posts
    25
    Spyder Garage
    0

    Default Rear Trunk Lid

    I just had the 3rd and 4th rear lights installed by Tricled. Now my rear trunk lid will not latch. Have anyone experience this problem?
    Reply With Quote Reply With Quote
  2. 07-08-2013, 02:55 PM #2
    mrfats
    mrfats is offline
    Very Active Member
    Join Date
    Jul 2011
    Location
    Morgantown, WV
    Posts
    582
    Spyder Garage
    0

    Default

    I have a 2011 and installed them myself. My trunk shuts fine. I'd have Tricled correct the problem. That shouldn't happen...
    Reply With Quote Reply With Quote
  3. 07-08-2013, 03:58 PM #3
    Jeriatric
    Jeriatric is offline
    Thinks out loud
    Join Date
    Apr 2012
    Location
    "The Skillet" AKA..... La Quinta, Ca
    Posts
    5,106
    Spyder Garage
    0

    Talking

    The piece that goes across the trunk and down to each side bag must be reinstalled properly. There's a tab under it that must be fitted correctly and the 8 screws should not be completely tightened until all has been adjusted and the lid is closing and latching properly. It's something you can correct without complete disassembly, if you're mechanically minded. If not, as has been said have them correct it. It'll only take a couple of minutes.
    Reply With Quote Reply With Quote
  4. 07-08-2013, 06:10 PM #4
    Bob Denman
    Bob Denman is offline
    Very Active Member
    Join Date
    Sep 2010
    Location
    Not Here
    Posts
    92,464
    Spyder Garage
    1

    Default

    You've got a bunch of Torx-heads across that inner lip, and two down on each side... (open up the side cargo areas...)
    It's a pretty easy piece to play around with to get lined up correctly; just DON'T twist it enough to bust it!
    2010 RT A&C, RT-L, RT-L , Orbital Blue, Cognac, Jet Black
    Reply With Quote Reply With Quote
  5. 07-08-2013, 08:28 PM #5
    Cruzr Joe
    Cruzr Joe is offline
    Very Active Member Cruzr Joe's Avatar
    Join Date
    Jul 2012
    Location
    Bryant, Arkansas
    Posts
    10,146
    Spyder Garage
    0

    Default

    Let the installer look at it to see why the lid won't close properly.

    When they are properly installed, they fit, look and work great

    Cruzr Joe


    Sent from my iPad using Tapatalk HD
    2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
    Reply With Quote Reply With Quote
  6. 07-09-2013, 07:01 AM #6
    Bob Denman
    Bob Denman is offline
    Very Active Member
    Join Date
    Sep 2010
    Location
    Not Here
    Posts
    92,464
    Spyder Garage
    1

    Default

    A Decent Ride 002.jpg
    2010 RT A&C, RT-L, RT-L , Orbital Blue, Cognac, Jet Black
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules