2015 rt heated seat wireing question

[gabby121]

my seat has a connector for the rear section but can,t find what to connect it to any one know what I am missing

[cognaccruiser]

Only thing that comes to mind is the sensor to tell the Spyder that there is a passenger sitting on the seat. Should plug from seat to Spyder under the seat. Am thinking you don't have a heated seat as it isn't standard. Others should be able to clarify/fill in the details.

Gary

[gabby121]

it has the oem heated seat and driver heated grips

[PW2013STL]

For the CanAm heated seat there is a large connector located on the left side under the panel below the small storage bin in front of the seat. The large seat connector plugs into that and Spyder's connector plugs back into that. From there the wire harness for the seat runs back along the gas tank to the rear and the small connector comes out the opening where the rear passenger seat plug comes out. That end gets connected to the seat. There is also a ground wire attached to the wire harness that you attach to the ground strap in the back towards the rear.

[gabby121]

thanks I will check that out

[gabby121]

the drivers section of the seat is connected to the driver heated grip switch the passenger section is not connected to anything am I missing a switch or a connector any help please

[PW2013STL]

the drivers section of the seat is connected to the driver heated grip switch the passenger section is not connected to anything am I missing a switch or a connector any help please

If the passengers heated grip is turned on then the passengers heated seat will turn on.

[gabby121]

it does no have heated passenger grips will I need them to get it to work

[PW2013STL]

it does no have heated passenger grips will I need them to get it to work

Yes