-
advise please
Hey everyone.
I posted this on the other forum but thought I would try here as well. I am having a problem with my 2011 RTS semi auto (under 300 miles). There is a loud squeeky noise around the front tire area when accelerating. If you let off on the throttle, the sound stops immediately. Braking seems to have no affect. I had so looked forward to riding this weekend but now I am concerned that I might cause damage to the bike if I continue to ride it.
Hubby was going to check drive belt but does not have the correct tool to remove the panels and our dealer is closed.
Any thought or ideas what this might be???
Thanks,
Dee
-
Don't know what the noise is but there should be all the tools needed to remove the panels under the seat in the tool kit.
-
Yes we went through the tool kit that came with the bike, but it was not there. Its the special wrench that has kinda like a "star allen wrench". Not sure if it was missing or just not included.
Thanks anyway.
Dee
-
they are called "torx" bits, you can get an inexpensive set at any hardware store either to fit a ratchet or screwdriver types.
-
Actually that is what we thought, in fact we hubby has several sets but he said this one was unique and what he has will not work. Will look further.
Again, I appreciate any suggestions. I guess I am just sad that its a nice afternoon and I can't get out and ride. Oh well there is always next weekend.
-
Very Active Member
Originally Posted by Spydee1
Yes we went through the tool kit that came with the bike, but it was not there. Its the special wrench that has kinda like a "star allen wrench". Not sure if it was missing or just not included.
Thanks anyway.
Dee
If your referring to the 2 silver security ones on both left and right panel those do not come out they hold the male part that attache to grommets.
do not remove them...
Freebob.. Hope that makes sense to you
-
If you are indicating the ones with the raised pin in the center they do not have to be removed to get the panels off, they hold a pin that goes into a rubber grommet to seciure the panel. these just pull out,be careful not to lose the grommet. The manual describes how to remove the panels although you do not have to remove nearly as many parts as they indicate. Look at Lamonster's post on how to change oil on an RT to get an idea of how to save some steps. Hope this helps, good luck!
-
Thanks everyone, I am going to the basement to discuss with hubby.
I really appreciate all the advise.
dee
-
Member
You make him stay in the basement???
-
Registered Users
Glo Ryders {4 sets (Blue, Red, Orange, Pink) I swap out}
Rear Trunk Liner ......... Seal Floorboards
Rear Trunk Shelf
Corbin Heated Seat
extra 12V plug
Elka shocks
White/Red fender lights
Bump/skid
Baker Wind Wings
Honey Burl Dash Kit
-
Your wife lets you come upstairs??? He must stay there to care for my Spyder. I even let him ride it when it needs gas
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|