-
Active Member
'16 RTS Rear Trunk Lid STUCK in closed position. Solution???
OK...new thread here. I've found several threads here focusing on this problem. It seems the advice offered thus far works on SOME RTs.
For some reason the '16 is different?? I know this is undoubtedly the most creative, problem-solving group of Ryders on the planet. So...
2016 RTS SE6
'64 Honda CA95 "Dream"
-
Very Active Member
I think if you get down underneath that lever you may be able to see where that cable is attached to the handle and hook on to it and give it a push with a screwdriver. Good luck
-
SpyderLovers Sponsor
Did you fix it? Call if you need to. Joe
Joe Meyer
Dealer for the Outlaw/ROLO laser Alignment system
-
Active Member
PXL_20240220_190349333.jpg
Sadly, the cable was broken...so....out came the hammers and physically removed the old latch & replaced with a new one. The solution suggested using screwdriver inserted in left latch did NOT have any effect on my '16. Again thanks to all for the suggestions and kind thoughts....yes, it was a PITA, but all is well now.
2016 RTS SE6
'64 Honda CA95 "Dream"
-
Yes, call Joe. He showed me how to access mine. It's not difficult.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|