-
Member
-
Very Active Member
It would help to know on what model.
-
Member
Originally Posted by EdMat
It would help to know on what model.
2014 year 1330 engine RTL
A video would help (slow learner)
Last edited by Peter Aawen; 09-29-2022 at 09:03 AM.
Reason: Caps & wound - would ;-)
-
Very Active Member
Originally Posted by cphillipsea1
2014 year 1330 engine RTL
A video would help (slow learner)
Whenever I have questions about how Spyderparts go together I will go the Fiche' ( from after-market parts) that shows how all the corresponding pieces fit together .... it has helped me in the past ..... good luck .... Mike
-
Very Active Member
Not a video but instructions for installing lighting from Spyderpops site. One of the steps is removing the tail lights.
https://spyderpops.com/brake-run-tur...odels-2010-19/
-
formerly pman2011
Here is a video for installing Saddlebag LED's which requires the removal of the rear lights. Disregard the section to remove the saddlebag inner panel.
https://www.youtube.com/watch?v=LyugJUNAnqc
[B]
2018 Intense Red F3T (See About Me under My Profile for mods)
2010 Timeless Black RT-622 Trailer
2014 Timeless Black RTS-SE6, 34,300 Miles, traded May 2019
2011 Timeless Black RTS-SE5, 15,180 Miles, traded April 2014
-
Very Active Member
I just checked my parts list in the manual. I have a 2011 but the rear tail lights are the same. I first remove the trim below the rear release latches. Open both side bags and rear trunk. There are 2 screw have to be removed from both sides. Then 4 screws around the rear trunk latch. Be careful on removing the left and right side fingers of the panel. After that panel is removed you have access to the light assemblies and this where you can also adjust the side latches. Bruce
New to Sue and I
2021, LTD, Asphalt Gray, 22,000 miles
Gone but not forgotten
RTS 2011 SM5, 95,000 miles
-
SpyderLovers Sponsor
What Safecracker said.
Why? The tail and brake lights are LEDs. If you say what you are trying to do, we can get you there. Joe
Joe Meyer
Dealer for the Outlaw/ROLO laser Alignment system
-
Very Active Member
Originally Posted by cphillipsea1
brake, tail, backup... I cannot get to them, doing something wrong?
Can someone tell me how to open it up to get to the bulbs.
Thanks
Brake and tail are in the LED assembly. You don't get to those. The backup and turn are incandescent. You have to remove the rear panel, 8 screws, to get to them.
2014 Copper RTS
Tri-Axis bars, CB, BajaRon sway bar & shock adjusters, SpyderPop's Bumpskid, NBV peg brackets, LED headlights and modulator, Wolo trumpet air horns, trailer hitch, custom trailer harness, high mount turn signals, Custom Dynamics brake light, LED turn signal lights on mirrors, LED strip light for a dash light, garage door opener, LED lights in frunk, trunk, and saddlebags, RAM mounts and cradles for tablet (for GPS) and phone (for music), and Smooth Spyder belt tensioner.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|