Results 1 to 6 of 6
  1. #1
    Member
    Join Date
    Aug 2009
    Location
    Cedar Park, TX
    Posts
    23
    Spyder Garage
    0

    Default Rear shock replacement 2018 - any tips?

    Does anyone have any tips for replacing the rear shock on my 2018 RTL? We ride 2 up a lot and I got Elias for the front and rear. I got the fronts on but had to take off the frunk to her to the top bolts. I am hoping the rear will not be as much hassle.

  2. #2
    Very Active Member
    Join Date
    Jan 2021
    Location
    Descanso, CA
    Posts
    997
    Spyder Garage
    0

    Thumbs up Rear shock installation example

    Excellent information on installing the rear shock is here https://www.spyderlovers.com/forums/...=1#post1591228

    My experience was similar but I purchased Ikon shocks https://www.spyderlovers.com/forums/...=1#post1610861

    PS get a service manual and follow instructions, especially if you have air suspension!
    Last edited by BertRemington; 02-12-2022 at 09:36 PM. Reason: added service manual recommendation
    2014 Can-Am Spyder RT-S SE6 Freeway Commuter Pod
    2016 Royal Enfield Classic 500 Fair-Weather Mountain Bike

  3. #3
    SpyderLovers Sponsor cptjam's Avatar
    Join Date
    Jul 2010
    Location
    Las Vegas, NV
    Posts
    3,850
    Spyder Garage
    0

    Default

    3/8” extension for your ratcheting wrench, with a wobble feature. Last one I did took a couple of hours. Easy, but lots of steps!
    Joe Meyer



    Dealer for the Outlaw/ROLO laser Alignment system

  4. #4
    Very Active Member
    Join Date
    Sep 2014
    Location
    USA
    Posts
    4,651
    Spyder Garage
    0

    Default

    You will have to remove the side panels. But you can get the top bolt from the side of the bike.

    The lower one can be done on the ground with the bike jacked up a bit.

  5. #5
    Active Member Bob L's Avatar
    Join Date
    Oct 2014
    Location
    Massachusetts
    Posts
    150
    Spyder Garage
    0

    Default

    I put on an Elka on my 2014 RT. Here is a video that I used for some guidance along with the instructions. https://www.youtube.com/watch?v=7O0Xf9eVpTc
    --
    Bob L.
    Worcester County Massachusetts
    www.rk-mass2.org

  6. #6
    Member
    Join Date
    Aug 2009
    Location
    Cedar Park, TX
    Posts
    23
    Spyder Garage
    0

    Default

    Hey thanks I got it done! The YouTube video was helpful. I did not have to take the rear trunk loose but needed to use 1/4 extension on top nut to avoid the assembly on the right side.
    Last edited by Peter Aawen; 02-15-2022 at 01:53 AM. Reason: tear = rear?? ;-)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •