Results 1 to 4 of 4
  1. #1
    Active Member m109anc's Avatar
    Join Date
    Jan 2011
    Location
    Apex, NC
    Posts
    74
    Spyder Garage
    0

    Default Harness for trailer installed on 2020 RTL

    Had the trailer harness installed on my 2020 RTL, plugged up trailer and the lights don't work. I pulled out my 12v tester, had someone press the brake while put the alligator clip on the ground terminal, then touch the other three terminals nothing. I repeated this with the turned signal, running lights, nothing. Any ideas what could be wrong?

  2. #2
    SpyderLovers Sponsor cptjam's Avatar
    Join Date
    Jul 2010
    Location
    Las Vegas, NV
    Posts
    3,850
    Spyder Garage
    0

    Default

    It’s not plugged in! Check fuses. Or, the module is defective. Do you know anyone with an F3T that has a trailer module? Unplug yours, plug in theirs. Test trailer. Same module. I’ve done several, no problems. I’m up, call.
    Joe Meyer



    Dealer for the Outlaw/ROLO laser Alignment system

  3. #3
    Member
    Join Date
    Jan 2019
    Location
    Crofton, KY
    Posts
    28
    Spyder Garage
    0

    Default

    If you paid someone to do this, take it back and tell them to do their job. Then have them show you that it is working. Don't accept faulty or shoddy workmanship.

  4. #4
    Very Active Member billybovine's Avatar
    Join Date
    Jul 2011
    Location
    Mitchell, Ontario, Canada
    Posts
    6,264
    Spyder Garage
    0

    Default

    Check the fuse. Refer to the owners manual for the specific fuse. Normally a 10 amp. If it is there and good. I would agree with Stubby. Take it back to the installer and tell them to fix it.

    2018 F3 LIMITED

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •