Results 1 to 6 of 6
  1. #1
    Active Member almosthere's Avatar
    Join Date
    Jan 2016
    Location
    Paw Paw, Michigan
    Posts
    141
    Spyder Garage
    0

    Default need help screw size?

    I am putting the primary muffler back on my 2015 RT-S SE6 and am missing the 3 small screws that hold the plate with the 2 front rubber hangers. Can anyone tell me the size that I might be able to pick them up at the hardware store? Or are they a speciality item only obtained at the dealer, if so what the part # might be?

  2. #2
    Very Active Member DGoebel's Avatar
    Join Date
    Oct 2016
    Location
    Faribault, MN
    Posts
    2,209
    Spyder Garage
    2

    Default

    From Cheapcycle parts, under the 2015 RTS SE6, Exhaust parts breakdown,
    https://www.cheapcycleparts.com/oemp...exhaust-system
    Hex. Forming Screw M6 X 20 Part # 210262050
    Safe Rides,
    David and Sharon Goebel
    Both Retired USAF Veterans
    2018 Anniversary Edition RT Limited
    Baja Ron ultimate swaybar. Vredestein tires, Baja Ron Front Shock Pre-load adjusters, Pedal Box, See my Spyder Garage
    IBA 70020

  3. #3
    Active Member almosthere's Avatar
    Join Date
    Jan 2016
    Location
    Paw Paw, Michigan
    Posts
    141
    Spyder Garage
    0

    Default

    thank you much
    So if I get 6mm x 20 at hardware store they should work?

  4. #4
    Very Active Member DGoebel's Avatar
    Join Date
    Oct 2016
    Location
    Faribault, MN
    Posts
    2,209
    Spyder Garage
    2

    Default

    Yes they should, I don't think there's any variation on thread pitch with Metric bolts at that size.
    Safe Rides,
    David and Sharon Goebel
    Both Retired USAF Veterans
    2018 Anniversary Edition RT Limited
    Baja Ron ultimate swaybar. Vredestein tires, Baja Ron Front Shock Pre-load adjusters, Pedal Box, See my Spyder Garage
    IBA 70020

  5. #5
    Active Member almosthere's Avatar
    Join Date
    Jan 2016
    Location
    Paw Paw, Michigan
    Posts
    141
    Spyder Garage
    0

    Default

    Thank you again will get those in the morning.

  6. #6
    Active Member almosthere's Avatar
    Join Date
    Jan 2016
    Location
    Paw Paw, Michigan
    Posts
    141
    Spyder Garage
    0

    Default

    Ok got the screws and was tight but got the front hanger plate re attached. primary muffler, (cat.), slid into front hanger rubbers fine. NOW how do you get the top rubber hanger to slide on to both hooks? I can slide it on to one or the other but can't seem to stretch it to go over both. Then it looks like the inside spring is going to be almost impossible to stretch to attach.
    HELP Please!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •