-
-
Very Active Member
Nice looking setup and reasonable price
Cruzr Joe
2018 F3 Limited, BRP Driver Backrest, Spyderpops Lighted Bump Skid, Dual Spyclops Light, Mirror Turn Signals, Laser Alignment, Engine LEDs, Fog Lights With Halo's, Cushion Handgrips, BRT LEDs, and Under Lighting, Lamonster IPS, (with Clock), F4 25" Vented Windshield with Wings, Airhawk "R" Cushions. Position 4 Brake setting, Short reach Handlebars, Dash Mounted Voltmeter and 12 Volt Plug. Set of 3rd pegs. Extended Passenger Seat. Exterior BRP Connect setup, Ultimate Trailer
-
Lots of interest...but no buyers yet
-
***SOLD***
-
There were no issues getting the Spyder through the door? I measured mine out and it is within a half inch or so, so I haven't tried it....
-
SpyderLovers Sponsor
If you were not in Texas but closer I would be right over with the $$$$$$$ Cash
-
Very Active Member
NEW OWNER OF THIS TRAILER
Originally Posted by the_bandit
***SOLD***
After looking at the tire marks and the other posters comments about WIDTH inside ..... Tell the new owner to put a 2 X 4 against each side wall on the floor ,,,,, this will absolutely keep the Spyder from scraping the walls ...... Like at the car wash, they act as guides .................... jmho ..... Mike
-
Originally Posted by PapaHotel
There were no issues getting the Spyder through the door? I measured mine out and it is within a half inch or so, so I haven't tried it....
It's definitely a tight fit but do-able (on my trailer anyways), to put my mind a little more at ease I went to a local hardware store and bought a couple of small pipe insulators w/ slit. Placed them on each of the lowering cables and rode on up. Kinda nerve-racking the first couple of times, but after that piece of cake.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|