DIY skid pan for GS/RS Spyder

[Warlock]

Here is some info and pictures to build it. The plate can be gotten here for a good price.I used Sibe Automation https://www.amazon.com/gp/product/B0...A1FWWCVO9POVQF
I used a jigsaw, drill, and belt sander to put a little bevel on the pan. sp1.jpgsp2.JPGsp3.JPGsp4.jpgsp5.jpgFirst picture is the template, second picture is width of the plate 20 1/4". Third picture is overall length 19 5/8". Forth picture is old plate on the template. The bottom of the old skidplate needs to be 3/8" from the bottom of the template before marking your holes to mount the plate. I used the same 6 bolt pattern from the old skid plate to mount the new skid plate. You can cut it 20 1/4" inch wide and drill your holes. Mount it with all the screws and from that you cut the noise to either fit or do like picture 5 and mark it and remove and cut the noise to your liking.
David

[Warlock]

More pictures.sp6.jpgThis is what the new skid looks compared to the old one. Lot more protection.
David

[Crisis]

That is darn nice. Want to sell me one?

[Warlock]

That is darn nice. Want to sell me one?

They are pretty easy to make. Only thing is the cost to ship these. Big companies pay a flat rate and would probably be twenty to thirty dollars to ship.
David

[Haze]

Very nice job. I love DIY.
Looks great and very cost effective.

[Warlock]

Had to do some editing to the post. Had posted the wrong measurements. It is 20 1/4" wide by 19 5/8" tall.
David