-
LED Tail Lights
Hello
How to connect LED lamps to the rear tail and STOP lights on my Spyder GS? If I install these LED lamps in place of the original lamps, I get a VSS error.
How can I solve this problem? It may be necessary to connect the resistor in parallel to the LED lamp? How much ohm should this resistor be?
Thank You!
p.s. Sorry for bad english...
Last edited by Questions; 03-12-2017 at 06:10 PM.
-
Very Active Member
-
Very Active Member
LED
I agree with Mike.
I have LEDs on my saddle bags. Wired in parallel with my OEM tail lights and have NO problems.
-
Very Active Member
LED Tail Lights
I just replaced the 1057 regular bulb with a 1057 LED, works fine no issues.
Al
All the great movements in the world began with a cup of coffee!
2018 F3-T
My mods: Can am Trailer hitch, USB and 12 volt power outlets, Gustason windshield, Bead rider seat cushion, battery harness for electric gear and battery tender, Time out trailer.
-
Last edited by Questions; 03-13-2017 at 02:42 AM.
-
Very Active Member
LED Tail Lights
Alex;
the 1057 designation is the USA two filament (combination brake and tail light in one bulb); you can find the number of your bulb on either the bulb itself or printed onto the base of the bulb. A 1057 LED is a exact replacement of a standard two filament bulb with an LED equivalent.
Hope this helps to clear up the confusion. Having never traveled out to the US, (except with my military service time) my knowledge of European or Russian standards is lacking entirely.
Al in Kalamazoo, Mi.
All the great movements in the world began with a cup of coffee!
2018 F3-T
My mods: Can am Trailer hitch, USB and 12 volt power outlets, Gustason windshield, Bead rider seat cushion, battery harness for electric gear and battery tender, Time out trailer.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|