-
Hi Bob
The vendor is replacing the shaft, I am going to make up my own with the changes to the dia of the threaded end of the shaft. I think that end of it needs to be a little more substantial then what is presently there. Thanks.
-
-
Hitches
To the Y community I have started thread that became a monster and a lesson for me. I posted this thread only to ask a question, this has turned into a question about the quality of a product. This was never the case it was an installation issue that's all. I may have contributed to this by stating I may make my own shafts. I should not have done that because again it was just an installation problem. I must apologize to Pierre as I have caused him harm by my statements. Pierre I am very sorry. If there was any one that stands behind there product its you .From the first day we met I knew you are a very nice person and the quality is first rate. Again my fault ...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|