Search:

2015 Can Am Spyder LT Limited
Beautiful Pearl Red
1330cc Rotax 115 Hp
Semi Auto 6 sp
Stability control
Traction control
One of a kind Dual hand Brake +standard foot brake
Abs Brake system...

I Have Dual Hand Brakes on my 2015 RT Limited. It required a little fabricating to mount the second Master cylinder.
I couldn't find a Dealer that would install it. So with a helper I did it myself....

The Kits are pre drilled and are just bolt on and well documented.You need to take Plastic off the right side and the slave cylinder and mounting bracket are installed from underneath. The hardest...

This explains how the Rust (Iron Oxide) is formed . Not my words found on Internet.

Fretting wear is surface damage that occurs between two contacting surfaces experiencing cyclic motion...

I don't think that I have a problem with my RT but after following this Thread I just can't help but give my opinion of what the problem is.As a Machinist/Shop owner of 55yr I have spent many hours...

If it fits your Budget and drives good I say Go For it and don' look back.
I had a 2013 Twin Rt and a 14 and 15 Rt triples and I loved that Twin for the bottom end power and sound.
If you can do...

That is the Rule Book.
They don't want to enforce because most players are Black and they don't want to agree with anything Trump says or does.

Thanks for Picture :yes:

Anyone have a picture of ECU and location on a 2015 RT?
How hard to remove?

If you need to pump your Master Cylinder is weak.I would replace Master Cylinder
and use pads from Baha Ron .I used the fully sintered and the first time I used under hard Braking I thought that I...

You can buy a left hand Master Cylinder and bracket from Isci if that would help.

He should move to a country that he can support.
The NFL should ban him.

I HAVE THE ebc fully SINTERED FROM Ron .
The stopping is much better than stock and work great.:yes:

I contracted Shingles 3 years ago on my rt Butt extending down to my knee and spent 3 months in bed
since I couldn't sit . Having Hip and back issues I could only lay on my back and it was...

I just put it in my RT and I'm not sure that I like it.:dontknow:
I have about 5 miles of 30-50 then about 10 miles of 70-80 then about 8 miles of 45-55
and it 's shaking till just before I pull...

Check Fuses I had an electrical problem that would blow a fuse that would shut everything down.:banghead:

Good Luck

http://dallas.craigslist.org/mdf/mcy/5586776819.html

Located in Mansfield, Texas,76063

:hun: Just to set the record straight the ISCI system is a hydraulic system and Yes it's expensive. But well engineered and very high quality.

I like the DIY project. A job well done. A few years...

:hun:

:wrong:I have the ICSI Hand Brake on both my Spyders , a 13RTL and a 15 RTL and have no problem activating the ABS system on either one. So you are not stop any quicker than that in an...

If it's cross threaded you can sometimes save it by carefully cleaning threads up by re-tapping. If there no threads left as in stripped you have 2 choices .One drill and tap to next size and drill...

350cc scooter

Where's the Beef?:yes:

I agree. It doesn't make sense to not leave room to maneuver on both sides.

The break even for a lot of the oil companies is about $35 barrel .Many lay offs still coming.

I agree. I have both a 13 RT Ltd with the twin and a 15 RT Ltd with the 1330. I love riding both and I feel like my twin is just as fast as the triple up to about 75 ,above that I give the edge to...

The gauges can be replaced with any 2 1/16" or 52mm gauge. I put a clock and volt meter in mine.

I had both my spyders laser aligned and was told that both were in spec and didn't need anything.
My 13 RT was pulling to the right a little even when in the left lane. I made the tool listed below...

TPMS saves a lot of bending .

I would ride it a little pumping the brakes. Bleed again with a helper using a clear hose in a clear container.
Starting at left front Pump until clear keeping the master cylinder reservoir topped...

I had the same problems with mine and bled mine several times and never could get a solid pedal.I took to the dealer and paid $450 to have them bleed while hooked to Buds with no better results...